I002940 Genio Rechargeable LED Portable Lamp

1. Install the Genio App and Register Account

For the best experience, download the "Mirabella Genio" app to your smartphone from the App Store or Google Play. You can also scan the QR code below; the app icon will be displayed after successful installation.

[QR Code for App Download]

[Download on the App Store]

[Get it on Google Play]

Launch the app from your smartphone and click the Sign Up button. Follow the on-screen instructions.

Diagram Description: The portable lamp features a USB charging port, a 'Mode' button, and an 'On/Off' button.

2. Charging the Light

Before using this product for the first time, please fully charge it using the supplied USB cable. It takes approximately 2 hours to fully charge the battery. While charging, a red light will be displayed. Once fully charged, a green light will appear. The run time of the light is approximately 10 hours.

3. Pairing using Mirabella Genio App

1. Press the on/off switch and wait for the portable lamp to start blinking (approximately 2 blinks per second).
2. Ensure your mobile phone is connected to a 2.4GHz Wi-Fi network. (5GHz is not supported and should be disabled on the router setting during pairing. Once the unit has been paired, 5GHz can then be re-enabled).
3. Launch the Mirabella Genio app, tap on the plus symbol [+] (located top right-hand corner).
4. Go to Smart Lighting -> Genio lighting devices.
5. Follow the app instructions to finish the pairing process.

If the lamp doesn't blink rapidly when first powered on, please try powering it off and on 3 times, or try powering on and holding the Mode button.

4. Trouble Shooting

If after the 100% countdown you receive a "time out" or "device not found error", this indicates that the app failed to communicate with the cloud services. Please ensure:

1. The light is blinking rapidly (2 blinks per second).
2. The 5GHz Wi-Fi signal is disabled on the router setting. For instructions on how to disable your 5 GHz Wi-Fi network, please contact your internet/router provider.

If you are using Telstra NBN, have disabled the 5GHz, and still cannot get it to pair, please follow the Guest Network pairing instructions on https://mirabellagenio.net.au/faqs. If you have done all the above, ensuring that the 5GHz is disabled, but still failed to connect, then your modem might be incompatible with smart devices.

All trademarks are used for reference purposes only. Made in China

MIRABELLA INTERNATIONAL PTY LTD

1 MIRABELLA DRIVE, TULLMARINE, VIC, AUSTRALIA 3043

TOLL FREE: 1800 636 528, www.mirabellagenio.com.au