Metra Installation Instructions for Part 95-7863

Dash Disassembly

Honda Element 2003-2010

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unsnap and remove the shift lever trim panel. For manual transmission models, untwist the shift knob. (See Figure A)
3. Unsnap and remove the center dash panel. (See Figure B)
4. Remove (4) Phillips screws and remove the radio.

Tip: As an option, only the center panel (the smaller piece around the radio) needs to be removed. Note: It is prone to damage, so full panel removal is recommended. (See Figure C)

Diagram Descriptions:

• Figure A: Illustrates the shift lever area, with arrows indicating the direction for panel removal.
• Figure B: Illustrates the center dash panel, with arrows indicating the direction for removal.
• Figure C: Shows the radio area and a U-shaped bracket, representing the O.E. Replacement panel.

Kit Assembly

Double DIN head radio provision

1. Attach the Double DIN brackets to the Double DIN trim plate. (See Figure A)
2. Slide the Double DIN head unit into the bracket/radio housing assembly and secure the Double DIN head unit to the assembly using the screws supplied with the radio. (See Figure B)
3. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. Note: Models equipped with a factory Double DIN radio will require the supplied O.E. Replacement panel. (See Figure C)
4. Reassemble the dash in reverse order of disassembly.

Diagram Descriptions:

• Figure A: Depicts the Double DIN brackets being attached to the trim plate.
• Figure B: Shows the Double DIN head unit being inserted into the bracket/housing assembly.
• Figure C: Illustrates the O.E. Replacement panel, a U-shaped component.