KALLAX Shelving Unit
IKEA Design and Quality IKEA of Sweden
Important Safety Information
WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.
Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.
This warning is repeated in multiple languages throughout the document.
Assembly Instructions
The following steps detail the assembly of the KALLAX shelving unit. Ensure you have all parts before beginning.
Tools Required (not included):
- Screwdriver (Phillips head)
- Hammer
- Level
- Pencil
Assembly Steps:
-
Attach the side panels to the base and top panels using the provided dowels and screws. Ensure the dowels are fully inserted.
Diagram shows two side panels being attached to a base panel with dowels and screws. A close-up shows a dowel being inserted into a panel and a screw being driven into another panel.
-
Insert the shelf dividers into the pre-drilled holes. Gently tap them into place with a hammer if necessary.
Diagram shows shelf dividers being inserted into the assembled frame. A close-up shows a shelf divider being tapped into place with a hammer.
-
Continue inserting shelf dividers, ensuring they are flush with the frame.
Diagram shows more shelf dividers being inserted.
-
Attach the back panels to the unit. These may slide into grooves or be secured with small nails or screws.
Diagram shows the back panels being attached to the shelving unit.
-
Secure the unit with the provided wall attachment hardware. Follow the instructions carefully to ensure the unit is safely secured to the wall.
Diagram shows the unit being secured to the wall with brackets and screws. A warning symbol is displayed indicating the importance of wall attachment.
Parts List:
- 8x Screws (part number 104321)
- 44x Dowels (part number 104322)
- 2x Wall attachment brackets (part number 100092)
- 2x Corner brackets (part number 121030)
- 3x Hexagonal decorative covers (part number 10002300)
- 1x Allen key (part number 103693)
- 2x Small brackets (part number 101339)
- 4x Small screws (part number 100372)
Final Check: Ensure all screws are tightened and the unit is stable and securely attached to the wall.
Important Note on Wall Attachment: Always use screws and plugs suitable for your specific wall type. If unsure, consult a professional. The provided diagrams illustrate various scenarios, including correct and incorrect wall mounting methods. The unit should be securely fastened to prevent tipping.
Diagrams on pages 16-19 show different configurations and wall mounting examples, including a warning against placing the unit on its side or upside down.
