Aquasana Claryum® Direct Connect: Owner's Manual for Filter Replacement

This guide provides essential instructions for replacing the filter in your Aquasana Claryum® Direct Connect Under Sink Water Filter system. Proper replacement ensures continued high-quality filtered water for your household. Please follow these steps carefully for a smooth and effective filter change.

Installation Steps

1. Turn off the cold water supply under the sink.
2. Remove the old filter by rotating it to the left until it unlocks, then pull down and discard.
3. Align the new filter's connection points with the system head, push in, and turn to the right until it locks. Hand tighten only; do not use tools.
4. Turn on the cold water supply to pressurize the system and check for leaks.
5. Turn on the kitchen faucet to cold water and run water through the system for at least 15 minutes to flush it. Do not drink the flushed water.

For a visual guide, scan the QR code provided in the original document to view a replacement video.

Support and Water for Life® Program

Aquasana offers a Water for Life® program designed to protect your investment and save you money through benefits like extended warranty, discounted replacements, free shipping, and no contract. For more information, contact Aquasana at 866-662-6885 or visit waterforlife@aquasana.com.

The Aquasana Claryum® Direct Connect system is certified by IAPMO R&T against NSF/ANSI Standards 42, 53, and 401. For a complete list of filtered contaminants, refer to the Performance Data Sheet available on Aquasana.com.

Aquasana recommends replacing the filter every 6 months or 784 gallons of use. Always use genuine Aquasana replacement filters for optimal performance. Do not use with microbiologically unsafe water without adequate disinfection.

Aquasana, Inc.
6310 Midway Road
Haltom City, Texas 76117
USA: 866.662.6885
Canada: 877.332.7873
www.aquasana.com