Aquasana Water for Life Program

INSTALLATION STEPS

1. Shut off the cold water valve under the sink. Release the pressure from the system by turning on the dedicated faucet. Once there is no longer any water flowing, you can proceed with replacing the filters.
2. Unbox filter replacements and remove plastic. Each filter is color coded to match the circle indicator on each filter housing.
3. Remove each filter housing from the system manifolds by turning the filter housing to the left. Pull down to detach. Ensure the filter housings are not on an angle while removing. This may result in damage to the o-ring.
4. Holding the filter housing over the sink, open it by turning the bottom counter-clockwise. Pour excess water down sink drain. Pull down on dirty filter to disconnect it from the filter housing. Continue this step for the second and third filter housing. While the housing is open, inspect each o-ring for damage. If damaged, replace immediately. If misaligned, gently move the o-ring into place.
   NOTE: If filter housing is too tight to disconnect by hand, please use the plastic wrench included with original system.
5. Press new replacement filter to the top of the filter housing using the appropriate color coded filters. Then, reconnect the bottom of the filter housing to the top half. Ensure connection points are correctly aligned, then turn clockwise to tighten. Continue this step for the second and third filter housing.
   NOTE: Do not use tools to tighten. Hand tighten only.
6. Reattach filter housing to bottom of the system manifold. Ensure connection points are correctly aligned, then push the filter housing up while turning clockwise. Continue this step for the second and third filter housing. Ensure all filter housings are attached and locked in place. Ensure the filter housings are not on an angle while reattaching. This may result in damage to the o-ring.
7. Open battery door and remove old battery. Insert new battery. When inserted correctly, system will beep five times and blink red.
8. Once all filter housings have been replaced and reattached, slowly turn water valve on. Turn off faucet and inspect for leaks. Then, flush system for 10 minutes before drinking.
   NOTE: Do not drink flushed water.

Scan to view the Claryum® 3-Stage filter replacement video.