T290 (Push Model) Quick Guide
This guide is intended for quick consultation only and does not replace the user and maintenance manual. Before using the machine, read the user and maintenance manual contained in the machine's packaging thoroughly and strictly follow all the instructions.
Preparation & Operation
Step 1: Add water (?) and chemical (?) to the designated tanks.
Step 2: Power on the machine (▶️ ON) and select the desired mode (⚙️ AUTO).
Step 3: Connect or adjust as indicated by the diagram (arrow pointing to connection point).
Step 4: Operate the lever as indicated by the diagram.
Step 5: Complete the final connection or adjustment as indicated by the diagram.
Step 6: Diagram shows the brush attachment mechanism, indicating placement and engagement.
Attaching/Removing the Brushes
Attaching the brush: Rest the brush on the floor in front of the machine and centre it with the guard. Lower the head and operate the brush/drive lever repeatedly until the brush automatically engages on the flange hub. If the operation is not successful, repeat by pressing on the lever again and repeating the centring.
Removing the brush: Raise the machine head by pushing the head lift pedal down and then to the right and operate the brush/drive lever repeatedly. After operating the lever a few times, the brush is released and falls to the ground.
Daily Maintenance
- Clean the dirty water tank.
- Check the suction filter is undamaged and clean.
- Check that the detergent outlet filter (?️) is clean.
- Check that the brush is clean. Replace if necessary.
- Check that the squeegee is clean and the blades are not worn.
Replacing the Squeegee Blades
Step 1: Open the clip (Ref. 1).
Step 2: Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Step 3: Remove the blade.
Step 4: Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a new blade, fitting it onto the screws on the body of the squeegee.
Step 5: Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing devices inwards.
Step 6: Close the hook again.
Step 7: Replace the squeegee on its support, following the instructions described previously.
