SLATTUM Upholstered Bed Frame

Step 1: Attach Side Rails to Legs

Connect the side rails to the legs of the headboard and footboard. Ensure correct orientation as shown in the diagram.

Visual aid: Two figures are shown. One holds parts, the other holds parts with a crossed-out symbol ❌, indicating a specific method to avoid.

Step 2: Secure Side Rails

Use the provided bolts and plastic connectors to secure the side rails to the legs. Avoid assembling on soft surfaces like carpets, as this may damage parts.

Visual aid: Figure assembling on a surface, followed by a figure with a crossed-out symbol ❌ and damaged parts, highlighting potential damage from incorrect assembly surface.

Step 3: Attach Second Set of Legs

Attach the remaining set of legs to the side rails. Ensure they are properly aligned.

Visual aid: Figure assembling parts, looking confused (❓), then figure on the phone (?) with IKEA logo, suggesting to contact IKEA for assistance if needed.

Step 4: Secure Second Set of Legs

Secure these legs using the appropriate bolts and plastic connectors.

Step 5: Install Central Support Beam

Attach the central support beam to the headboard and footboard legs using the long bolts (106918) and the hex key (130445).

Step 6: Connect Support Structure Components

Connect the various parts of the central support structure. Be cautious of potential pinching hazards or sharp edges.

Visual aid: Warning symbol ⚠️ indicating caution with fingers and sharp/moving parts.

Step 7: Install Bed Base Supports

Two people are shown installing the bed base support structure onto the frame.

Step 8: Attach Central Support Feet

Attach the feet to the central support beam using the short bolts (105107) and plastic feet (191315).

Step 9: Slide in Side Panels

Slide the side panels into their designated slots on the bed frame.

Step 10: Secure Side Panels (First Set)

Use medium bolts (128574) and washers (130445) to secure the first set of side panels.

Step 11: Secure Headboard/Footboard Connections

Use small bolts (112091) and washers (130445) to secure the connection points at the headboard and footboard.

Step 12: Slide in Remaining Side Panels

Slide the remaining side panels into place.

Step 13: Secure Side Panels (Second Set)

Use medium bolts (128574) and washers (130445) to secure the second set of side panels.

Step 14: Secure Headboard/Footboard Connections (Repeat)

Repeat the process from Step 11 to secure the headboard and footboard connection points with small bolts (112091) and washers (130445).

Step 15: Attach End Caps/Supports

Attach end caps or supports to the central beam using the provided bolts (130445) and plastic parts (10050800).

Step 16: Place Bed Slats

Carefully place the bed slats onto the support structure. An arrow indicates the direction of placement.