Best Choice Products 12V Ride-On with Remote

About Best Choice Products

As shoppers, Best Choice Products (BCP) aims to find the perfect balance between quality and value. Their diverse catalog of everyday essentials is tailored to customers and guaranteed to offer high quality at a low price.

Important Safety Information

General Safety:

• Assembly must be performed by an adult who has read and understood the instructions.
• Keep packaging and small parts away from children during assembly and use.
• Always use common sense and safe practices when operating this vehicle.
• This product may contain chemicals known to the state of California to cause cancer or birth defects or other reproductive harm.
• NOTE: For best performance, use only on flat, hard surfaces.
• Age Range: 3 to 8 years old
• Weight Capacity: 61 lbs.

Safety Hazards (May result in serious injury or death):

• Keep children away during assembly; remove all packaging material and parts from underneath the vehicle.
• Never open the battery. Batteries contain lead and lead compounds (acids) that are toxic, corrosive, and known carcinogens.
• Keep limbs, hair, and clothing away from moving parts. Always wear shoes. Do not wear loose clothing.
• This vehicle does not have brakes. Do not leave a child unattended during operation. Do not use in locations requiring braking capability, as this could lead to loss of control.
• Avoid operating near streets, motor vehicles, steep inclines, steps, bodies of water, sloped surfaces, hills, wet areas, flammable vapors, alleys, at night, or in the dark.
• Avoid operating in unsafe conditions like snow, rain, loose dirt, mud, sand, or gravel, as this may cause tipping or damage to the electrical system or battery.
• Do not operate in an unsafe manner, such as pulling the vehicle with another vehicle, allowing more than one rider, pushing the user, or traveling at an unsafe speed.

Battery Warnings

• Use only the supplied rechargeable battery and charger. Using other batteries or chargers may cause fire or explosion.
• Never use the supplied battery and charger with another product.
• Charge the battery in a well-ventilated area, away from heat or flammable materials. Explosive gases are created during charging.
• Avoid direct contact between battery terminals, as this may result in fire or explosion. Always pick up the battery by its case or handles, not by the wires.
• Keep all liquids away from the battery. Contact with battery leakage may cause serious injury. If contact occurs, flush with cool water for 15 minutes. If swallowed, give water or milk. Do not induce vomiting if the person is vomiting or has decreased alertness.
• Battery posts, terminals, and related accessories contain lead and lead compounds, which are known carcinogens and are toxic and corrosive. Never open the battery.
• Tampering with the electric circuit system may cause shock, fire, or explosion, and permanently damage the system. Keep the charger housing closed.

Specifications

Assembly Instructions

Tools Required: Plastic Wrench (provided), Phillips Screwdriver, 2 AAA Batteries (for remote)

Hardware: 2 Springs (2 pcs), M4 x 12mm Screws (4 pcs)

Parts List:

• A: Rear Axle (1 pc)
• B: Wheel (4 pcs)
• C: Cap (4 pcs)
• D: Front Axle (1 pc)
• E: Steering Wheel (1 pc)
• F: Windshield (1 pc)
• G: Side Mirrors (L/R) (1 set)
• H: Seat (1 pc)
• I: Backrest (1 pc)
• J: Back Frame (2 pcs)
• K: Back Bar (1 pc)
• L: Frame Light (2 pcs)
• M: Remote Control (1 pc)
• N: 12 Volt Charger (1 pc)

Step 1: Flip the vehicle over. Remove all parts and packaging. Lift the rear gearbox frame. Remove two screws from the mounts, insert the gearbox frame, and replace screws. Insert gearboxes into slots.

Step 2: Remove nuts/washers from the rear axle (Part A). Slide the rear axle through the gearboxes, ensuring it's positioned evenly.

Step 3: Slide a wheel (Part B) onto the rear axle and secure with a nut/washer. Snap on a cap (Part C). Repeat for the other side. Use plastic wrenches to tighten nuts in opposite directions.

Step 4: Remove two nuts from the bottom of the front axle (Part D). Remove the nut on the steering column. Insert the front axle and two springs (Part 1) into the front frame. Insert the steering column into the front axle. Replace nuts to secure.

Step 5: Remove nuts/washers from the front axle (Part D). Slide a wheel (Part B) onto the front axle and secure with a nut/washer. Snap on a cap (Part C). Repeat for the other side.

Step 6: Flip the car onto its wheels. Connect the steering wheel (Part E) connector to the steering mount connector. Remove the steering wheel nut and bolt, slide the wheel onto the mount, and replace the nut and bolt.

Step 7: Snap on the windshield (Part F) and side mirrors (Part G).

Step 8: Within the seat, insert the battery connector into the designated terminal on the circuit board. Ensure correct orientation.

ATTENTION:

• A: Connect the power connector before assembling the seat. Press the Start button (picture 2) to operate.
• B: After charging, unplug the charger first, then press the Start button (picture 2) to operate.

Step 9: Attach the seat (Part H) with two screws (Part 2).

Step 10: Attach the backrest (Part I) with two screws (Part 2).

Step 11: Slide two frame lights (Part L) onto the back bar (Part K). Slide the back bar into the two back frames (Part J). Insert the back frame assembly into the rear of the car.

Charging Instructions and Warnings

• The charging port is located below the seat. Insert one end of the charger into the port and the other into a wall outlet.
• Charge the battery for 12 hours before initial use.
• Average charging time is 8-12 hours. Do not charge for more than 20 hours, as this can cause permanent damage and void the warranty.
• Do not allow the battery to drain completely, as this may cause damage.
• Check the battery and charger for wear or damage before charging. Do not charge if damaged.
• Only an adult who has read and understood the safety warnings should handle, charge, and recharge the battery.

Caring for Your Ride-On

• Park indoors or cover with a tarp to protect from wet weather.
• Store in shade or cover with a tarp to prevent fading from prolonged sun exposure.
• Do not wash the vehicle with a hose or soap.
• Charge the battery at least once a month to prolong its life.

Dashboard Diagram

Push down on the pedal to drive forward/reverse. Release the pedal to slow down and stop.

Dashboard Controls: Lights, Ignition Sounds, Power, Horn, Forward/Reverse Pedal, Media Player.

Under Seat: High/Low Speed Switch, Charging Port.

High Speed/Low Speed: Adjusts the speed of the vehicle, including reverse speed.

Media Player

• Back/Volume-: Short press for previous song/station; long press to decrease volume.
• Play/Pause/Seek: Play/pause music; seek radio stations.
• Forward/Volume+: Short press for next song/station; long press to increase volume.
• Mode: Toggle between music and FM radio.

Bluetooth Connectivity

1. Place your audio device near the media player and power on the car.
2. Press 'Mode' on the media player until you hear "Bluetooth device is ready to pair."
3. On your audio device, go to Bluetooth settings and select "Best Choice Products Ride On."
4. When connected, select your desired song.

Remote Control

Controls: Speed Select, Forward, Park/Stop, Reverse, Turn Right, Turn Left.

• Remote control operation OVERRIDES manual operation (pedal will not work).
• The remote enters power-saving mode after a period of non-operation.

Linking the Remote Control:

1. Turn the vehicle off.
2. Install 2 AAA batteries into the remote. Indicator lights will flash.
3. Turn the vehicle on. Solid indicator lights indicate a successful link.
4. If lights continue to flash (unsuccessful link), remove and reinsert batteries and repeat steps 1-3.

Troubleshooting

Warnings Regarding Batteries

• Do not mix battery types (alkaline, carbon zinc, nickel hydride).
• Do not mix old and new batteries.
• Do not charge non-rechargeable batteries.
• Charge rechargeable batteries under adult supervision only.
• Remove exhausted batteries.
• Do not short-circuit supply terminals.
• Keep batteries away from heat sources and do not hit them against hard objects.
• Do not submerge batteries in water.
• Insert batteries with the correct polarity.

California Proposition 65 Warning

Battery posts, terminals, and related accessories can expose you to chemicals, including lead and lead compounds, known to the State of California to cause cancer and birth defects or other reproductive harm. These are toxic and corrosive. Wash hands after handling. For more information, go to www.P65Warnings.ca.gov.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this product may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by:

• Reorienting or relocating the receiving antenna.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consulting the dealer or an experienced radio/TV technician for help.

WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Responsible Party (for FCC matters only): Quality Control Dept., 15101 Red Hill Ave., Tustin, CA 92780

Product Warranty Information

Items can be returned for any reason within 60 days of receipt for a full refund, provided they are in original packaging with all accessories. Returns will be refunded to the original payment method and are not subject to a restocking fee.

A Return Authorization (RA) number is required for all returns and can be obtained from Best Choice Products Customer Service. Items received without an RA may not be accepted or may experience processing delays. Refunds or replacements will be processed within 5 business days of receipt.

All returns must be shipped back to the Best Choice Products Return Center at the customer's expense. If the return is due to a Best Choice Products error, a pre-paid shipping label will be provided via email. Customers are responsible for providing return shipping boxes.

Pictures may be required for some returns to ensure the item is not damaged prior to return. Items are not considered undamaged until received and verified by Best Choice Products. Any damages to items are the customer's responsibility until acknowledged as undamaged by Best Choice Products.

General Warning

Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from incorrect attachment, improper use, inadequate maintenance, or neglect of this product.

More Products

Check out more great products at bestchoiceproducts.com.

Best Choice Products Rewards

Earn points while you shop. Join today! Give your friends 15% off their first order! For each successful referral, you'll receive 100 points.

Help Center

Questions about your product? Visit help.bestchoiceproducts.com.

Services available: Chat Support, Product Inquiry, Orders FAQ, Product Assembly, Returns & Refunds.