Anslut Solar Cell LED Lighting
Item No. 019713
Product Description
Hangable, balloon shaped and colourful solar cell light that spins in the wind. The lamp has two warm white LED bulbs that produce a soft light. Runs on a rechargeable AAA battery (included).
Symbols
- ? Read the instructions.
- CE Approved in accordance with the relevant directives.
- ♻️ Recycle discarded product in accordance with local regulations.
Technical Data
| Battery type (rechargeable) | AAA |
|---|---|
| Battery technique | NiMH |
| Battery voltage | 1.2 V |
| Battery capacity | 300 mAh |
| Light source | LED |
| Colour temperature | 3000 K |
| Colour tone | Warm white |
| Luminous flux | 0.6 lm |
| Output | 62 mW |
| Protection rating | IP44 |
| Size | H114 x Ø26 cm |
Solar Cell Powered Light
The product runs on solar energy via the built-in solar panel. The solar panel converts solar energy to electrical energy, which is used to charge the rechargeable NiMH battery. The light switches on automatically when it goes dark, and switches off in daylight. How long the light stays on depends on how long the solar panel has been exposed to sunlight.
- Long exposure to sunlight produces longer lighting up.
- For best functionality, place the product so that it is exposed to sunlight and is therefore charged for as long as possible.
- With maximum exposure to sunlight the light will shine for up to 8 hours.
Use
- Carefully remove all the parts from the packaging.
- Start the product with the power switch (1).
- Place the product in the required place.
Notes:
- Keep sharp objects away from the surface of the solar panel to prevent scratching and damage.
- The functionality of the product can be checked by covering the top of the solar panel – the light should go on if the product has started.
- It is difficult to see the LED light in bright ambient light. The product works best in the dark. This does not mean that the product is not working.
- For best functionality, allow the product to charge for one day before using for the first time.
Replacing the Battery
Follow the instructions to replace the rechargeable AAA battery (NiMH).
- Unscrew the screws on the bottom of the casing with a screwdriver and open the battery cover.
- Replace the battery with a new one of the same type (rechargeable AAA battery, 1.2 VDC, 300 mAh, NiMH).
- Replace the battery cover and firmly tighten the screws.
Important Notes:
- Do not mix old and new batteries.
- Do not mix alkaline batteries with ordinary batteries or rechargeable batteries (NiCd, NiMH etc.).
Diagram Descriptions
Figure 1:
Shows the assembled solar light and a close-up of the top section, indicating the solar panel (1) and LED (2).
Figure 2:
Illustrates the solar light in different states or forms, with a power switch (1) indicated.
Figure 3:
An exploded view of the battery compartment, showing screws, casing, battery cover, and the battery itself.
