Product Description
The Anslut Solar Cell LED Light is a practical, solar-powered lamp designed for outdoor use. It can be fastened around handrails, railings, or similar structures. Featuring a built-in twilight sensor, the lamp automatically turns on when darkness falls and switches off in daylight. It operates using rechargeable AAA batteries, which are included.
Key Components:
- Solar panel
- Casing
- Light source
Diagram 1 Description: This diagram shows the solar cell light fixture from various angles, with labels pointing to the solar panel, the main casing, and the light source.
Diagram 2 Description: This illustration shows the light fixture with a rod-like component (labeled 1) extending from its base, suggesting a mounting option.
Diagram 3 Description: This image depicts the process of attaching the light fixture to a surface, likely a wall or post, using screws and a screwdriver.
Solar Powered Operation
The product is powered by solar energy, utilizing its integrated solar panel. The solar panel converts sunlight into electrical energy, which is used to charge the internal rechargeable AAA battery (NiMH).
The light automatically activates at dusk and deactivates at dawn.
The duration of the light's illumination is dependent on the amount of time the solar panel is exposed to sunlight. Extended exposure leads to longer lighting periods. For optimal performance, position the product to maximize its exposure to sunlight for charging.
Under conditions of maximum sunlight exposure, the lamp can provide light for up to 8 hours.
Assembly
Read all instructions carefully before proceeding with assembly.
- Carefully remove all components from the packaging.
- To activate the product, pull out the plastic tab situated between the battery and the contact plate.
- Place the product in its desired location.
Diagram 4 Description: This diagram shows a screwdriver being used to remove screws from the underside of the casing, indicating how to access the battery compartment.
Diagram 5 Description: This illustration shows the battery cover opened, revealing the battery compartment. An upward arrow suggests the removal of the cover.
Diagram 6 Description: This close-up view displays a battery with clearly marked positive (+) and negative (-) terminals, emphasizing the correct polarity for installation.
Maintenance
Replacing the Battery
Follow these instructions for replacing the rechargeable AAA battery (NiMH).
- Unscrew the screws located on the bottom of the casing using a screwdriver and open the battery cover.
- Replace the battery with a new one of the exact same type (rechargeable AAA battery, 1.2 VDC, 100 mAh, NiMH). Ensure correct polarity is observed.
- Close the battery cover and securely tighten the screws.
Important Battery Information:
- Do not mix old and new batteries.
- Do not mix alkaline batteries with ordinary or rechargeable batteries (such as NiCd, NiMH etc.).
Technical Data
| Parameter | Value |
|---|---|
| Output | 0.015 W |
| Colour temperature | 3000 K |
| Luminous flux | 0.8 lm |
| Protection rating | IP44 |
| Battery technique | NiMH |
| Battery type | AAA |
| Battery capacity | 100 mAh |
| Voltage | 1.2 V |
| Size | L 8 x W 4.5 x H 4.3 cm |
Legal and Recycling Information
[CE approved]: This product is approved in accordance with relevant directives and regulations.
[Recycle symbol]: Discarded products must be recycled in accordance with applicable local regulations.
For the latest version of the operating instructions, please visit: www.jula.com
