Groov-e GV-CR02 Radio Curve

Product Overview

Packaging Contents:

• FM Alarm Clock Radio *1 pc
• Type-C USB cable *1 pc
• User Manual *1 pc

Device Diagram Description:

The Groov-e GV-CR02 Radio Curve features a large, clear LED display for time and alarm status. Key controls and components include:

• LED Display: Shows time (12/24 hour format), PM indicator, FM status, alarm indicators (ALM1, ALM2), and sleep mode status.
• Top Panel Buttons: MEM+/TUN+, MEM-/TUN-, SNOOZE/DIMMER, VOL+, VOL- ALARM 2, ALARM 1.
• Rear/Side Controls: 12/24 TIME SET, SLEEP, ON/OFF, USB TYPE-C PORT, DC IN.
• External Features: Telescopic ANTENNA, SPEAKER.

Important Safety Information

• Keep the product and all its parts out of reach of small children.
• Do NOT expose the device to high temperatures, as plastic parts may warp. Avoid placing naked flame sources, such as lighted candles, on the product.
• Do NOT expose the device to low temperatures, as moisture can form inside, potentially damaging the circuit board.
• Do NOT attempt to open the product. It contains no user-serviceable parts. Unauthorized handling will void your warranty.
• Disconnect the Radio from the mains power supply during thunderstorms.
• Always ensure the Radio is completely switched off before changing or disconnecting the power supply.
• If the Radio will not be used for an extended period, remove all batteries from the compartment and unplug the mains power.
• Never throw batteries into a fire or attempt to open the outer casing. Batteries should not be exposed to excessive heat (e.g., sunshine, fire). Dispose of old batteries carefully.
• Batteries are harmful if swallowed; keep them away from young children.

Caution: Danger of explosion if batteries are incorrectly replaced.

Operation

Charging the Battery:

Before use, fully charge the battery using the supplied Type-C USB cable (approx. 4 hours). Connect to any USB power source (Laptop, AC Charger, Car Charger, etc.). A solid white light indicates charging; the light turns off when fully charged. A full charge provides approximately 72 hours of standby time (Dimmer and Radio off).

Turning the Radio On/Off:

Press the ON button on the back of the radio to turn it on. Press the OFF button on the back to turn it off.

Setting the Clock:

While in clock mode (radio off), long press the "Time Set" button. The hour will flash. Short press "MEM-/TUN-" or "MEM+/TUN+" to adjust hours (check the PM LED for AM/PM). Short press "Time Set" again. The minutes will flash. Short press "MEM-/TUN-" or "MEM+/TUN+" to adjust minutes. Short press "Time Set" to save and exit.

12/24 Hours Mode:

Switch between 12 and 24-hour clock modes by pressing the 12/24H button on the back of the radio.

FM Radio & Channel Scanning:

Short press the "ON/OFF" button to turn the FM function on or off. Long press "ON/OFF" to automatically scan and save channels. Long press "MEM-/TUN-" or "MEM+/TUN+" to manually scan for channels.

Moving a Preset Channel:

Short press "MEM-/TUN-" or "MEM+/TUN+" to select a station. Long press the "SLEEP" button; the LED screen will display a flashing "P..". Use "MEM-/TUN-" or "MEM+/TUN+" to choose a preset position number (P01-P20). Press "SLEEP" again to save the channel. Repeat as needed. Short press "VOL" buttons to adjust volume.

Alarm Mode:

While in clock mode (radio off), short press the "Alarm Clock 1" button twice to turn Alarm Clock 1 on or off. When the Alarm Clock 1 indicator is lit, long press the "Alarm Clock 1" button. The hour number will flash; adjust with "MEM-/TUN-" or "MEM+/TUN+". Short press "Alarm Clock 1". The minute numbers will flash; adjust with "MEM-/TUN-" or "MEM+/TUN+". Short press "Alarm Clock 1" again. Select the alarm tone (BUZ for Buzzer, RAD for FM radio) using "MEM-/TUN-" or "MEM+/TUN+". Short press "Alarm Clock 1" to save settings. If Radio (RAD) is selected, it defaults to the last listened channel. After setting the tone, short press "Alarm Clock 1". The display will show "VOL number"; adjust the volume (Vol 5 Min to Vol 16 Max) with "MEM-/TUN-" or "MEM+/TUN+". Short press "Alarm Clock 1" to save. When the alarm rings, it starts at Vol 5 and ascends. To stop a ringing alarm, short press "Alarm Clock 1"; it will stop and ring again the next day at the same time unless switched off. Alarm Clock 2 follows the same procedure.

Sleep Mode:

While in FM radio mode, short press the "Sleep Mode" button to select auto-off times: 120, 90, 60, 45, 30, or 15 minutes. The sleep LED on the display will illuminate to confirm sleep mode is active. Select "OFF" to turn off Sleep mode.

Snooze/Dimmer Function:

Snooze: When the alarm rings, short press the "Snooze/Dimmer" button. The alarm stops, and the alarm indicator flashes, confirming snooze is active. The alarm will ring again after 9 minutes.

Dimmer: Short press the "Snooze/Dimmer" button to choose from 4 brightness levels for the display: Off, Low, Medium, or High.

Features

• USB or Battery operated
• Rechargeable battery 1200mAh
• Digital alarm clock - wake up to radio or buzzer
• FM radio
• 20 Preset stations
• White LED display
• Large display 120 x 50 mm
• Dual alarm setting
• 12H/24H time mode
• 16 level volume adjustment
• Dimmer (high, medium, low, off)
• Snooze (9 mins)
• Sleep mode
• Telescopic antenna
• Type-C USB charging cable (included)
• Input DC 5V/1A

Feature Icons:

? Rechargeable Battery ? FM Radio ⏰ Dual Alarm ? LED Display ? Display Dimmer

Battery Removal/Disposal & Environment Protection

Battery Disposal:

This product contains batteries and should not be treated as normal household waste; it should be recycled. Please take it to your nearest collection facility. For further details, contact your local council or visit www.recycle-more.co.uk. Batteries contain substances that may be harmful to the environment and human health. Keep out of the reach of children and seek immediate medical help if swallowed. Never throw batteries into a fire or attempt to open the outer casing. For advice on safely removing your battery, visit www.groov-e.co.uk.

Environment Protection:

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. [?? UK CA ♻️ CE ?]

Guarantee

Groov-e guarantees this equipment against defects in workmanship or materials for one year from the date of purchase. The product will be repaired or replaced free of charge if proven defective within this period. Claims should be made through the authorized dealer/retailer or directly with Groov-e. This guarantee is valid only when purchased and retained within the United Kingdom with proof of purchase. It excludes damage from accident, misuse, wear and tear, neglect, improper installation, or use inconsistent with safety standards. Alterations, adjustments, data loss from malfunction, or damage to third-party devices are also excluded. Groov-e is not liable for damage during transit or if the serial number plate is altered. Consequential damage is excluded, except where liability cannot be restricted by law. Carriage costs are borne by the purchaser. The guarantee is personal to the original purchaser. A test fee may apply if the equipment is found to comply with specifications. This guarantee is in addition to statutory consumer rights.

Declaration of Conformance

Groov-e declares that this product is in compliance with the essential requirements and other relevant provisions of the Radio Equipment Directive 2014/53/EU. The complete declaration of conformity can be requested from Groov-e.

Groov-e Contact Information:

Groov-e
Unit J
Braintree Industrial Estate
Braintree Road
Ruislip
Middlesex
HA4 0EJ UK

Website: www.groov-e.co.uk
Email: info@groov-e.co.uk
Telephone: 020 8839 0978

Register your purchase for extended warranty: www.groov-e.co.uk/warranty

Made in China