WORX Landroid Robotic Mower: Get Started Guide

Introduction

This Get Started guide is intended to help you begin using your WORX Landroid robotic mower. It does not replace the full Instruction Manual, which must be read and understood before operating the product. Ensure your Landroid is kept updated with the latest software. You can download both the guide and software updates at www.worx.com/landroid/support.

Installation Guide

In the box

The package typically includes:

• Landroid Robotic Mower
• Base Station
• Boundary Wire
• Wire Connectors
• Stakes
• Charging Contacts
• Power Adapter
• Instruction Manual

Installation Steps

Follow these steps to install your Landroid:

1. Base Station Placement: Position the base station on a level surface, ideally within the mowing area, with at least 30 cm (≥30cm) clearance on the sides and 80 cm (≥80cm) clearance from obstacles in front. Ensure at least 1 meter (≥1m) clearance from corners.
2. Boundary Wire Installation: Lay the boundary wire around the perimeter of the lawn. Maintain specific distances from lawn edges and obstacles: approximately 26 cm (10.2 inches) from the lawn edge, 10 cm (4 inches) from obstacles, and 4 cm (1.5 inches) from the base station.
3. Wire Connection: Connect the ends of the boundary wire to the terminals on the base station, ensuring the correct "OUT" and "IN" connections.
4. Power Connection: Connect the power adapter to the base station and plug it into a power outlet.
5. Mower Placement: Place the Landroid mower onto the charging contacts in the base station to begin charging.

Note: Precise measurements for wire placement and clearances are critical for optimal performance. Refer to the diagrams for exact positioning relative to lawn edges, obstacles, and corners.

Operation Guide

Your Landroid M and Landroid L models are operated via an intuitive interface.

Initial Setup

1. Upon first startup, you will see a "Welcome" screen.
2. Follow the on-screen prompts to set up your preferences, including entering a PIN code for security. You may need to confirm the PIN code multiple times.
3. Configure the mowing schedule and other settings as prompted.

During Operation

• The display will show the current status, such as "Work done today", "Charging 50%", or "Cutting grass".
• The mower will indicate when it is "Leaving house and starting blade" – exercise caution during this phase.
• You can switch the mower to "MANUAL" mode if needed.

For detailed operational instructions and troubleshooting, please visit www.worx.com/landroid/support or watch available videos.

Maintenance and Care

To clean your Landroid, avoid using high-pressure water jets (❌). Use a damp cloth or brush for cleaning (✔️) to ensure proper maintenance.

Support and Resources

For further assistance, detailed manuals, software updates, and video tutorials, please visit the official WORX Landroid support website:

www.worx.com/landroid/support