Safety Warnings
These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location.
This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.
Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. This product must be used on a stable, flat surface.
Under no circumstances must this lamp be covered with any material as this could pose a safety hazard.
This product is not suitable for persons under 14 years of age.
This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
The lamp must be protected by a 3 amp fuse in the mains plug.
Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.
Never put anything on the product or hang anything on any part of this product.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Troubleshooting
When the bulb does not light after installation:
- Please plug in and operate the foot switch to turn your lamp on.
- Please check the bulb.
- Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Plug Conversion
To use this item in Europe, the 3 pin adaptor can be removed by loosening the central screw and removing the adaptor to reveal the 2 pin Europe plug.
Converting 3 pin to 2 pin plug
This section illustrates how to convert the 3-pin plug to a 2-pin plug for European use.
- Step 1: Shows a standard UK 3-pin plug, identified by the 'BS 5733' marking. A screwdriver is depicted, positioned to remove the central screw securing the plug's casing.
- Step 2: Illustrates the process of loosening the central screw with the screwdriver, indicated by a curved arrow. The plug's casing begins to open, revealing the internal components.
- Step 3: Depicts the final state where the 3-pin adapter has been removed, exposing the 2-pin European plug. The removed 3-pin adapter and its components are shown separately.
Multi-language Support
A QR code is present, accompanied by text indicating its purpose: "Scan QR code for multi-language". Below this, a list of languages and their corresponding prompts are provided:
- EN: Scan QR code for multi-language
- FR: Scannez le code QR pour plusieurs langues
- ES: Escanee el código QR para varios idiomas
- PL: Zeskanuj kod QR dla wielu języków
- DE: Scannen Sie den QR-Code nach mehreren Sprachen
- IT: Scansiona il codice QR per multilingua
Manufacturer and Certifications
Website: www.lampgenius.co.uk
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg
Certifications include UKCA Mark, CE Mark, and WEEE symbol (crossed-out wheeled bin).
One moment, please...
