LI261420 - Quell Touch Table Lamp, Tinted Glass, Nickel

Safety Warnings

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.

This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location.

This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.

Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. This product must be used on a stable, flat surface.

Under no circumstances must this lamp be covered with any material as this could pose a safety hazard.

This product is not suitable for persons under 14 years of age.

This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.

This is a 3-stage touch lamp. Simply touch the base of the lamp to change brightness (Dim/Bright/Brightest).

PLEASE NOTE – A bulb with minimum wattage of 3W must be used for this table lamp to function correctly.

The lamp must be protected by a 3 amp fuse in the mains plug.

Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.

Never put anything on the product or hang anything on any part of this product.

If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

Care and maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).

Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Troubleshooting

When the bulb does not light after installation:

• Please plug in and operate the lamp to turn your lamp on.
• Please check the bulb.
• Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.

If you have any doubt about installation/use of this table light, consult a qualified electrician.

Converting 3 pin to 2 pin plug

To use this item in Europe, the 3 pin adaptor can be removed by loosening the central screw and removing the adaptor to reveal the 2 pin Europe plug.

Step 1: Locate the central screw on the 3-pin plug adapter.

Step 2: Loosen this screw to detach the 3-pin adapter.

Step 3: Remove the 3-pin adapter to reveal the 2-pin plug.

The diagram illustrates converting the 3-pin plug to a 2-pin plug. Step 1 shows the 3-pin plug with an arrow indicating the central screw. Step 2 shows the central screw being loosened and the 3-pin adapter beginning to detach. Step 3 shows the 2-pin plug after the adapter has been removed.

Assembly Instructions

The assembly diagram shows the lamp components. Label 01 points to the lamp base. Label 02 points to the bulb socket. Label 03 points to the light bulb.

Follow these steps for assembly:

1. Insert the light bulb (03) into the socket (02) on the lamp base (01).
2. Ensure the bulb is securely fitted.
3. Plug the lamp into a suitable power outlet.

Manufacturer Information

UK Manufacturer: BH17 7BY

EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg

Certifications: UKCA, CE

Multi-language Information

QR codes are provided to access the manual in multiple languages, including English, French, Spanish, Polish, German, and Italian.