Installation and Safety Instructions

Safety Warnings

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.

This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location.

This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.

Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. This product must be used on a stable, flat surface.

Under no circumstances must this floor lamp be covered with any material as this could pose a safety hazard.

This product is not suitable for persons under 14 years of age.

This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.

The lamp must be protected by a 3 amp fuse in the mains plug.

Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.

The lampshade part can be adjusted to an appropriate angle as needed.

Never put anything on the product or hang anything on any part of this product.

If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

Care and Maintenance

For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).

Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Troubleshooting

When the bulb does not light after installation:

• Please plug in and operate the foot switch to turn your lamp on.
• Please check the bulb.
• Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.

If you have any doubt about installation/use of this product, consult a qualified electrician.

European Plug Conversion

To use this item in Europe, the 3-pin adaptor can be removed by loosening the central screw and removing the adaptor to reveal the 2-pin Europe plug.

Diagram Description: Converting 3 pin to 2 pin plug

The diagram illustrates a 3-pin electrical plug. It shows a central screw that, when loosened, allows the outer casing of the 3-pin plug to be removed, exposing a standard 2-pin plug underneath, suitable for European sockets.

Assembly Instructions

Refer to the provided diagrams for assembly steps. The diagrams show the main components of the floor lamp and how they connect using specific fasteners.

Fasteners Included:

• Screw A: 6 pieces (Longer thread)
• Screw B: 1 piece (Shorter thread)

Important Note: Screw B must only be used on the indicated area shown in the assembly diagram.

The assembly diagram depicts the structural assembly of the floor lamp. It highlights specific connection points for screws. For instance, points labeled 'A' on the diagram indicate where Screw A should be used, and point 'B' indicates where Screw B should be used. These screws are essential for joining the various parts of the lamp frame and base.