LI074010 - Wisp Pendant Light, Large, Glass, Metallic Gold, 32cm
Installation and Safety Instructions
Safety Warnings
These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply in accordance with current IEE wiring regulations, and should be installed in accordance with local building regulations. It is for domestic ceiling use only, and is not suitable for a bathroom location.
This is a Class I product and must be Earthed. The terminal blocks are supplied according to requirements of the fitting.
IMPORTANT: Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation.
The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for "masonry" only. Other fixings are not supplied and must be purchased.
Decide on the position of the light fitting or remove existing light fitting. Note the position of the electrical connections, and ensure there is a solid mounting surface, Preferably a wooden joist or joist bridge, to support the weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
Never put anything on the product or hang anything on any part of this product.
IMPORTANT: Ensure that all electrical connections are tight and that no loose strands are left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
Care and Maintenance
For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Troubleshooting
When the bulb does not light after installation:
- Ensure there is no electricity failure.
- Ensure all the connections are secure.
If you have any doubt about installation/use of this light from Lamp Genius, consult a qualified electrician.
Assembly Instructions
Follow these steps for assembly:
Attach the mounting bracket to the ceiling using the provided screws (1) and wall plugs (2). Ensure the mounting surface is solid, preferably a wooden joist or joist bridge, to support the weight of the light fitting. Take care not to drill into any pipes or mains cables.
Connect the wires from the ceiling to the corresponding terminals on the fitting: Live (L) to L, Neutral (N) to N, and Earth to the [earth symbol] terminal. Ensure all connections are tight and no loose strands are left out.
Use the adjustment mechanism (4) to set the suspension cable to your desired length. The cable can be adjusted up or down.
Secure the main body of the light fitting to the mounting bracket. Then, attach the canopy (5) to cover the wiring and mounting hardware.
Insert a suitable bulb (7) into the socket. Ensure the bulb wattage does not exceed the specification on the label to prevent overheating and damage.
Carefully attach the glass shade (9) to the fitting. Ensure it is securely fastened.
Verify that all parts are securely attached and electrical connections are correct before restoring power.
For multi-language instructions, scan the QR code provided in the original document.
Lighting, Lights, And Light Fittings | Lamp Genius
