HPRT HM-A300E Mobile Label Printer

Printer & Accessories

The printer is packaged with the following accessories. If any of these accessories is broken or missing, please contact the dealer that you bought the product.

• Printer
• USB Cable
• AC Adapter
• Battery Pack
• Quick Start Guide

Note:

• The AC adapter may vary by local or region.
• The items in the package are actually based on the order.

Appearance and Components

Front View

Components:

• [MODE] Button
• LCD
• Paper Roll Perspective Window
• Cover-opening Button
• Paper Feed

Top View:

• Battery

Open View:

• Paper Guide
• Platen
• Thermal Print Head
• Tear Bar
• USB Interface

Loading Paper

1. Press the cover-opening button to open the paper cover.
2. Unlock the paper guide as shown below. [Unlock Symbol] [Lock Symbol]
3. Load the paper in the orientation shown in the figure below. Make sure that the thermosensitive layer is facing down. Adjust the paper guide per the paper width. After adjusting, lock the paper guide. [Correct Paper Orientation Symbol] [Incorrect Paper Orientation Symbol]
4. Pull some extra paper and close the cover. Make sure that it is closed on both sides. [Arrows indicating closing the cover]
5. Use the tear bar to tear the extra paper. [Arrow indicating tearing paper]

Battery Pack Installation

1. Make sure that the printer has been turned off before you insert or remove the battery pack.
2. Insert the battery pack into the back of the printer as in the figure shown below, following the direction of the arrow. Press down on the battery pack until the hook clicks into place. [Arrow indicating battery insertion]
3. To remove the battery pack, pull back the hook, and use the opposite procedure from the one you used to insert the battery pack. [Hook release illustration]

Battery Charging

Please charge the printer with the supplied USB cable.

Charging Options:

• Charge via PC [Laptop Icon]
• Charge via AC Adapter [AC Adapter Icon]

When the battery pack runs out of power, the battery icon on the LCD will flash. It powers off automatically when continues printing. If you want to continue printing, please charge it.

Menu Settings

1. Press and hold the [MODE] button for approximately 2 seconds, and the printer will turn on.
2. Press and hold both the [MODE] button and the [FEED] button. The main menu will be displayed on the screen, showing options such as: language, density, sleep time, print, calibrate.
3. Press the [MODE] button to change the option.
4. Press the [FEED] button to change the category of sub-option; press and hold the [FEED] button to confirm the current setting.

CAUTION:

Before changing the menu settings, make sure that the communication with a host device is disconnected. When the printer is under Bluetooth communication with a host device, it cannot enter the Menu Settings mode.

FCC ID: 2AUTE-A300X

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.