Product Features
- BE LISS straightening head with Tensio Control System® (4 settings: 1. waves, 2. loose curls, 3. tight curls, 4. very tight curls)
- 38mm thermal brush with ceramic coating
- 20mm round boar-bristle brush
- 25mm round styling brush
- Power: 1200W
- Ionic technology: provides shine and antistatic effect
- 3 speed settings
- Cool air button: sets the hairstyle
- Swivel cord
- Hinged rear filter for easy maintenance and extended unit life
Fitting and Removing Attachments
To attach: Align guides on the unit and attachment, then press together until you hear a click. To remove: Press the unlocking buttons located on the sides of the unit and gently pull the attachment off.
Usage
The brush has 4 settings: 0 (off), I (low airflow), II (medium airflow), and III (high airflow). The low setting is ideal for fine hair, the high setting for thicker hair.
The separate ‘cool air’ button makes it easy to use a shot of cool air at the end of straightening or blow-drying to set the movement of each section and give it a ‘long-lasting’ effect.
Use your hot air straightening brush on pre-dried, slightly damp hair that is completely tangle-free. Work on one section at a time (maximum 2cm wide), starting with the sections underneath. Always work from the roots to the tips and slide the brush slowly down the length of the section.
The BE LISS Straightening Head
Perfect straightening and shine!
Select the tension for your hair type using the Tensio Control System® (1. waves, 2. loose curls, 3. tight curls, 4. very tight curls). (See Figure 1 for settings).
Hairstylist Advice: For first use, select tension setting 1 (the lowest setting) to become familiar with the BE Liss straightening head. Gradually increase the setting until you find the tension that works best with your hair.
Careful! Whatever straightening you adopt, we recommend holding the tips of the section to be straightened with your free hand so that you can keep your hair evenly distributed between the teeth of the straightening head. And before each stroke make sure the thin section is properly positioned with the roots at the base of the comb, then slowly and steadily slide the unit down the length of hair while holding the tips with your free hand. (See Figure 2 for technique).
The 38mm Thermal Brush with Ceramic Coating
For perfect glide and better protection of your hair.
The combination ‘brush/hair dryer’ will revolutionize your blow drying! This ideal diameter, recommended by BaByliss, creates a smooth movement and adds body to your hair without tangling it, for the best blow-dry results for hair full of softness.
The hot air of the unit heats the metal barrel of the attachment. The heat is thus distributed directly over your hair making it soft and smooth.
The 20mm Round Boar-Bristle Brush
This size is more specially suited for the finishing touches: this brush will accentuate the shaping of certain sections like the fringe, the tips or the roots.
The use can also vary according to the length of your hair:
- On short hair, it can be used horizontally, like the thermal brush, for gentle and natural blow-drying with the ends flicked out or turned under.
- On long hair, it can be used vertically for a spiral curl effect at the tips.
The Round Styling Brush
This brush can be used on dry or damp hair and is perfect for curling and adding body to your hair!
Take up a section of hair, brush it from the roots to the tips with the brush then coil the hair around it. Hold for 15 to 20 seconds depending on the thickness of the section. Let the hair cool before combing it out.
Maintenance of the Unit
- Unplug the unit and allow to cool completely before cleaning or storing.
- We advise you clean the straightening head and brushes regularly to avoid build-up of hair, styling products, etc. Use a comb to remove hair from the brushes. Use a dry or very slightly damp cloth for the plastic and ceramic surfaces.
