BaByliss AS122E Smooth Finish Hair Styler

How to Use

• Ensure hair is 80% dry and combed to remove tangles.
• Create a parting and divide hair into sections ready for styling.
• Secure the selected attachment onto the handle.
• Slide the switch to the heat setting suitable for your hair type to turn the appliance on.
• After use, slide the switch to the '0' setting to switch off and unplug the appliance.
• Allow the appliance to cool before storing.

Changing the Attachments

• Place the attachment onto the handle and align the two indents with the buttons on the handle.
• Push the attachment onto the handle until it clicks into place.
• To remove an attachment, press and hold the two buttons and pull the attachment away from the handle.

Attachment Guide

38mm Thermal Brush Attachment

Place the brush head under a section of hair, close to the roots. Use the brush to lift the hair at the roots to create volume. Slowly move the brush down along the section, towards the ends of the hair. Repeat for each section.

25mm Firm Bristle Brush Attachment

Place the brush head under a section of hair, close to the roots. Use the brush to lift the hair at the roots as you style. Move the styler down the section, towards the end of the hair. Repeat for each section.

20mm Soft Bristle Brush Attachment

Use the soft bristle brush attachment to smooth the hair. Place the brush head under a section of hair, close to the roots. Use the brush to lift the hair at the roots as you style. Move the styler down the section, towards the end of the hair. Repeat for each section.

Smooth Blow-Dry Brush Attachment

Place the brush head under a section of hair, close to the root with the bristles pointing upwards. Use the other hand to pull the hair section taut against the brush head. Gently slide the brush head through the section of hair, until you reach the ends. Repeat for each section.

Heat Settings

There are 3 heat settings plus a cool shot button (*). Slide the switch to select low heat 'I', medium heat 'II', or high heat 'III'. Press and hold the '*' button to activate the cool shot.

Note: Use lower heat settings for delicate, fine, bleached, or colored hair. Use higher heat settings for thicker hair.

Cleaning & Maintenance

General Cleaning

• Ensure the appliance is switched off, unplugged, and cool.
• Wipe the exterior with a damp cloth. Ensure no water enters the appliance and it is completely dry before use.
• Do not wrap the cord around the appliance; coil it loosely by the side.
• Do not use the appliance with a stretched cord.
• Always unplug after use.

Cleaning the Filter

• Ensure the appliance is switched off, unplugged, and cool.
• Holding the handle firmly, lift the filter open from the grooves near the cord bushing.
• Using a soft brush, clean any hair and debris from the filter.
• Replace the rear filter by closing the filter lid shut.