Costway LED Vanity Bathroom Mirror BA8043DE

Product Overview

This document provides instructions for the installation, operation, and maintenance of the Costway LED Vanity Bathroom Mirror BA8043DE. It is designed to enhance your bathroom experience with its integrated LED lighting and anti-fog function.

Before You Start

Please read all instructions carefully and retain them for future reference. Ensure all parts and hardware are present before beginning assembly. Assemble the product near its intended location to avoid unnecessary movement. Always place the product on a flat, steady, and stable surface. Keep small parts and packaging away from children to prevent choking hazards.

Function Description

• On/Off Button: The button turns blue when connected to the main power supply. A short press turns the mirror on/off. A long press adjusts the brightness (dimming). Release your finger when the desired color/brightness is achieved.
• Anti-fog Function: Pressing the defog button heats and defogs the mirror. Press again to exit. The anti-fog function automatically stops after 60 minutes of continuous operation to prevent damage from high temperatures.
• Time Display: Press and hold the defog button for 3 seconds to adjust minutes, then press defog and on/off buttons to increase/decrease. Press and hold the defog button again for 3 seconds to adjust hours, then press defog and on/off buttons to increase/decrease. The display will automatically stop after 3 seconds of flashing once the correct time is set.

Installation Steps

1. Measure: Measure the distance between the hanging holes of the mirror.
2. Mark: Mark the position of the holes on the wall.
3. Drill & Install Anchors: Drill holes and install the provided plastic anchor bolts.
4. Attach Screws: Arrange the screws on the wall and ensure stability.
5. Connect Power: Connect the mirror body to the power supply. The mirror is supplied with a plug. If a wall switch is used, the plug can be cut off and connected to the wire. Ensure the main power supply is off before wiring.
6. Hang Mirror: Hang the mirror on the mounting bar.

Packaging List

• LED Mirror x1
• Wall Screw x3
• Plastic Anchor Bolt x3
• Installation Instruction x1
• Mounting Bar x1
• Gloves x2

Tools You May Need (not included)

Hammer, Pliers, Screwdriver, Drill, Measuring Tape, Pencil

Maintenance

Turn off the power before cleaning. Use a soft, dry cloth for cleaning. Do not use cleaning agents or abrasive materials. Avoid moisture contact with the lamp.

Return / Damage Claim Instructions

• Do not discard the original packaging. Items must be returned in the original box.
• Take photos of the box markings and any damaged parts.
• Send an email with the requested images and a description of your claim to the seller via the marketplace where the item was purchased.