Prio
Rear position
To enable full tilt, set the wheel position to A3. In other positions, use the stated number of clips to reduce tilt to avoid a clash between the tilt mechanism and the cross beam.
NB. When fitting attendant controls to Prio, you will need to reverse or reposition the tilt handle (see illustration).
[Illustration: A diagram showing a hand adjusting a lever on a wheelchair's tilt mechanism. Arrows indicate rotational movement for tilt adjustment.]
Twist R on Prio – 24" and 22" rear wheels
Use 24" linking bracket for 24” rear wheels. Use 22" linking brackets for 22” rear wheels.
| Wheel position | 1 | 2 | 3 |
|---|---|---|---|
| Pos A | ✔️ 16° (2 clips) | ✔️ 16° (2 clips) | ✔️ 12° (4 clips) |
| Pos B | [NC] | ✔️ 10° (5 clips) | ✔️ 6° (7 clips) |
| Pos C | [NC] | ✔️ 6° (7 clips) | ✔️ 6° (7 clips) |
| Pos D | [NC] | [NC] | [NC] |
| Pos E | [NC] | [NC] | [NC] |
[NC = Non-conformance]
[Illustration: A diagram showing connection points labeled E, D, C, B, A, and 'a', connected to an 'Adapter'. This indicates different mounting positions or configurations.]
Twist is not compatible in the rear position on wheelchairs with an attendant brake, including 16” rear wheel configuration.
To connect in the rear, select the correct Klaxon cross beam length using the chart below:
Klaxon Cross beam selection for Etac Prio
| Etac seat width | Etac product code |
|---|---|
| 35 cm | [NC] |
| 37.5 cm/40 cm | KXLKT0061 |
| 42.5 cm | KXLKT0062 |
| 45 cm | KXLKT0063 |
| 47.5 cm | KXLKT0064 |
| 50 cm | KXLKT0065 |
| 52.5 cm | KXLKT0066 |
