KuKirin A1 Electric Scooter User Manual

General Information and Warnings

This manual provides essential information for the safe operation and maintenance of the KuKirin A1 electric scooter. It is crucial to read and understand all instructions before use.

WARNING! Stop operating this product if it is damaged. Worn or damaged components must be replaced promptly to avoid riding risks.

WARNING! Please place the vehicle packaging and various components in a rational order, and keep them away from children to avoid accidental ingestion.

Daily Maintenance

• Regularly check tire pressure and maintain proper pressure.
• Ensure both brakes are functioning correctly.
• Check the tightness of all screws and nuts.
• Wipe the e-scooter surface with a clean cloth to prevent water from entering electronic elements.

Battery Maintenance

• Turn off the power and avoid full discharge when charging or leaving the e-scooter idle.
• For long-term idle periods, store the e-scooter in a safe place with the battery capacity above 50%. Charge at least every 3 months.
• Avoid using and storing the battery at extreme temperatures.
• Use only the original KuKirin charger.

Regular Overhauling

• Regularly inspect the scooter frame, front fork, and suspension components for damage.
• Monthly overhauling is recommended. Apply a small amount of white lubricant grease or oil into the folding mechanism every 6 months.

Storage

Store the vehicle in a flat, stable, well-ventilated, and dry venue. Avoid direct sunlight or excessively humid places for extended periods. Keep the e-scooter clean.

Brake Calibration

If the braking force is too tight: Loosen the braking arm nut, slightly shorten the brake wire, tighten the nut, and test the brake.

If the braking force is weak: Loosen the braking arm nut, slightly lengthen the brake wire, tighten the nut, and test the brake.

Tire Inflation

If tire pressure is low, inflate the tire using an air pump. Remove valve caps, attach the pump connector to the tire valve, and inflate.

Replace the Foot Board Grip

Remove the rubber pad on the foot board surface to replace the pedal leather.

Shaky Bracket Adjustment

Check and tighten the vertical tube screw and the two folding mechanism screws using a hex wrench if the bracket is loose.

Folding and Unfolding

1. Unleash the three safety buckles, press the folding handle downward, and bring down the upright tube.
2. Hook the folding hook into the tail hook to complete the folding.
3. Open the folding latch to fold the scooter front.
4. Fold the scooter body and hook the hook in place.

Transportation and Parking

1. Lift the scooter with one or both hands.
2. Release the kickstand and park the scooter in the correct place after riding.

Dashboard and Switch Group

The dashboard displays information such as speed, mileage, battery capacity, and headlamp status. Key components include the meter, brake levers, throttle, and switches.

Schematic Diagrams

The scooter comprises a dashboard, headlamp, pole, folding wrench, front fender, training wheel, kickstand, folding handle, mood light, charging port, front shock absorber arm, tail pedal, rear fender, and motor.

Assembly and Operation Guide

1. Open the package and take out the scooter and accessories.
2. Release the kickstand, expand the upright tube, and lock the folding handle.
3. Align the front connector, insert it into the upright tube, and lock the screws on both sides.
4. Complete the installation.

Precautions

• Ensure handlebars are properly and securely installed.
• Charge the battery fully before initial use. Charge promptly when the battery capacity is low.
• Check the charger, cable, and plug for damage before charging.
• Braking distance is longer in wet conditions; brake earlier.
• Avoid riding in rain, storms, or snow. Water damage to electrical components can cause explosions.
• This product is for single-person use only. Do not carry passengers.
• Do not perform acrobatic stunts. Do not refit or modify the scooter.
• Keep the scooter away from flammable materials and open flames.
• Always wear shoes when riding.
• Check and observe local regulations concerning e-scooter riding.

Riding Precautions

• Do not exceed the maximum load capacity (120kg).
• When driving, stand on the foot board with one foot forward, push off, and then accelerate using the throttle. Use the brake lever to slow down or stop.
• Combine braking and deceleration for smooth control, especially in wet conditions.
• Avoid obstacles like curbs or steps. Judge and adjust trajectory and velocity. Maintain a safe distance from pedestrians.
• When encountering dangerous obstacles, dismount and push the scooter.
• When parking, brake gradually, stabilize the vehicle, and use the kickstand. Turn off the power and remove the key.

Potential Safety Risk Avoidance

• Wear a helmet and protective equipment.
• Ensure all dashboard functions are working before riding.
• Use the throttle cautiously when pushing the scooter.
• Maintain balance during starting and stopping.
• Grip handlebars firmly and accelerate smoothly.

Troubleshooting

Warranty and Client Support

Prohibition: Do not use unauthorized accessories or additional items.

Warranty period: 1 year for controller, instrument, motor, battery, charger, frame, wheels, brakes, folding mechanism, telescopic tube, front fork, brake system, and throttle dial.

Customer service: Contact authorized service center or dealer for component repair or replacement. Provide accurate purchase information.

EC Compliance Declaration

Manufacturer: Jinhua Feimi Intelligent Technology Co.,Ltd.

Address: No. 14, South Mudan Street, Baiyang Street, Wuyi District, Jinhua City, Zhejiang Province, China

Description: Electric dual-wheel scooter, KuKirin

This declaration confirms compliance with EU directives including Machinery (2006/42/EC), Low Voltage (2014/35/EU), EMC (2014/30/EU), and RoHS 2.0.

Parameter List

Maintenance and Repair

E-scooter cleaning: Clean the main frame with a soft, damp cloth. For persistent stains, use toothpaste, scrub, and wipe with a damp cloth.

Charging

The charger indicator is red during charging and green when fully charged. Charge the battery to maximum capacity before initial use. Charge after each use and before it is depleted. Use only the original KuKirin charger. Turn off the scooter during charging. Use a power socket range of 100V-240V. Do not expose the battery to high temperatures or moisture. If the battery is damaged or contacts water, do not charge or use it. Keep the battery away from small metal objects. Do not swallow battery cells. Ensure the battery is correctly positioned. Remove the battery if the scooter is idle for a long time. Tighten the charging port plug when not charging. Do not ride the scooter while charging.

Dangerous Behavior Prohibition

• Observe local laws and regulations.
• Do not use electronic devices while riding.
• Do not ride with only one hand or foot.
• Always hold the handlebars.
• Do not charge indoors.
• Single-person use only. No passengers.
• Do not ride up/down stairs or over obstacles.
• Avoid touching hot disc brakes immediately after riding.