KuKirin G2 Master Operation Manual

Product Overview

The KuKirin G2 Master is an electric scooter designed for personal use. Please refer to the actual product for precise details as images in this manual are for reference only.

Recommended User Profile:

• Age: 14-60 years
• Height: 130-190cm

Safety First: Always wear protective gear, including a helmet, knee pads, elbow pads, and wrist guards, to minimize the risk of injury.

Table of Contents

1. Precautions
2. Warnings
3. Diagram
4. Parameter Table
5. Packing List
6. Assembly Guide
7. Tips for Beginners
8. Operation Mode
9. Troubleshooting
10. Charging
11. Maintenance
12. Warranty
13. Warranty Card

1. Precautions

To ensure the best performance, comfort, enjoyment, and safety while riding, it is essential to familiarize yourself with your new electric scooter. Please read these instructions carefully before use.

Initial Ride: Begin your first ride in a safe and controlled environment, away from traffic, obstacles, and other riders. Avoid riding on highways, public roads against traffic, or in rainy conditions. Slow down and navigate around flooded areas.

Riding Responsibly: The scooter is a vehicle with inherent risks. Do not use your phone or wear headphones while riding. Understand and adhere to local traffic regulations for electric scooters on public roads.

Protective Gear: Always wear a qualified helmet before riding. It is highly recommended to use additional protective equipment such as elbow and knee pads for enhanced safety.

Legal Compliance: Electric scooters may require mandatory basic equipment that varies by region. Ensure your scooter is equipped according to local laws and regulations if riding on public roads.

Usage: This product is intended for personal use only. Do not use it for commercial purposes. Keep this user manual for future reference.

2. Warnings

• Pre-Ride Check: Before each ride, verify tire pressure, ensure the handlebar is properly mounted and tightened. Confirm the battery is fully charged. If the battery depletes during a ride, continue at a slow, steady speed and recharge as soon as possible.
• Charger Safety: Inspect the charger, cable, and plug for any damage before charging. Do not use a damaged charger.
• Braking on Wet Surfaces: Braking distance is typically longer on wet roads than on dry roads. Brake earlier to ensure a safe stop.
• Weather Conditions: Avoid riding in rain, storms, or snow whenever possible. Exposure of electrical components (control unit, motor, battery) to moisture or water can cause irreversible damage or battery explosion.
• Single Rider: This product is designed for a single adult rider only. Do not carry additional passengers. Do not ride if you feel unwell or are under the influence of alcohol or drugs.
• Product Awareness: The scooter is not a toy. Like other vehicles, there are risks such as falls and collisions. Do not allow individuals unfamiliar with its operation to use the scooter. If lending your scooter, ensure the borrower understands all warnings, instructions, and safety precautions and can operate it safely and responsibly.
• Fire Safety: Keep the scooter away from flammable objects and open flames.

3. Diagram

The complete scooter's noise level is less than 70 dB.

• Handlebar Clamp: Quick-release clamp for the stem.
• Stem: The vertical bar connecting the handlebars to the scooter body.
• Folding Button: Button used for folding the scooter.
• Headlight: Front illumination.
• Front Fender: Protects from debris.
• Integrated Lithium Battery: The power source of the scooter.
• Wheel Motor: Powers the scooter's movement.
• Dashboard Screen: Displays speed, battery level, etc.
• Hook: For securing the folded scooter.
• Rear Fender: Protects from debris.
• Silicone Pedal: Footrest area.
• Rear Wheel Motor: Powers the scooter's movement.

4. Parameter Table

5. Packing List

Please check carefully for any missing items or damage. If found, please contact us.

• 1. User Manual *1
• 2. Air Pump *1
• 3. Screwdriver Tools and Accessories
• 4. Charger *1

6. Assembly Guide

Unpacking & Assembly:

1. Turn the knob to fix the folding switch.
2. Place the handlebar tube into the bracket.
3. Tighten the screws and check the power switch.

Folding & Unfolding:

1. Lower the hook and pull the stem.
2. Pull the stem upwards.
3. Turn the knob to lock the folding clip.

7. Tips for Beginners

• Protective Gear: Always wear protective gear, including a helmet, knee pads, wrist guards, and elbow pads.
• Practice Riding: Practice riding until you can comfortably mount, move forward, turn, stop, and dismount the scooter.
• Avoid Obstacles: Avoid riding over objects that can stick to the wheels or get caught between them.
• Choose Safe Routes: It is best to choose relatively wide roads and avoid riding on slopes, pedestrian areas, or surfaces with obstacles until you are proficient in riding.

8. Operation Mode

Controls:

• Screen: Displays speed, mileage, battery, etc.
• Brake Lever: Controls the brakes.
• Handlebar Cover: Decorative and protective covering for the handlebars.
• Headlight Switch: Turns the headlight on/off.
• Left/Right Turn Signal Switch: Activates turn signals.
• Single/Double Drive Switch: Toggles between single and dual motor drive modes.
• Thumb Accelerator: Controls acceleration.
• Power Switch: Turns the scooter on/off.
• Horn: Audible warning device.

Display Indicators:

• Speed: Current speed.
• Left Turn Signal: Indicates left turn signal is active.
• Right Turn Signal: Indicates right turn signal is active.
• Non-Zero Start: Indicates if the scooter requires a push to start.
• Single Drive: Indicates single motor operation.
• Dual Drive: Indicates dual motor operation.
• Voltage: Battery voltage.
• Battery Indicator: Shows remaining battery level.
• Headlight Indicator: Shows if the headlight is on.
• Speed Limit Indicator: Indicates speed limit settings.
• Speed Gear: Displays the current speed gear (e.g., 1, 2, 3).
• Speed Unit: Displays the unit of speed (km/h or mph).
• Mileage/Error Code: Displays trip distance or error codes.
• Cruise Indicator: Shows if cruise control is active.

Operation Instructions:

1. Power On/Off: Long press the power button.
2. Speed Gear Selection: Short press the power button to cycle through three speed gears.
3. Drive Mode Selection: Short press the single/double drive switch to toggle between single and dual drive modes.
4. Menu Settings: Short press the power button three times consecutively to enter the menu settings (P1, P2, P3, P4, P5, P6, P8, PA, PB).
   • P1: Kilometer/Mile selection (default: kilometer).
   • P2: Voltage level setting (36V/48V/52V/60V/72V, default: 52V).
   • P3: Wheel diameter setting in inches (adjustable 080-160, default: 100).
   • P4: Number of magnetic poles for speed measurement (1-100, default: 30).
   • P5: Cruise control mode selection (0: disable, 1: enable, default: disable).
   • P6: Zero start and non-zero start setting (0: zero start, 1: non-zero start, default: zero start).
   • P8: Standby mode duration setting (0: no standby; other numbers indicate duration in minutes, default: 5 minutes).
   • PA: Acceleration force setting (1-5, 1=min, 5=max).
   • PB: Braking force setting (0: disable; 1-5: braking force increases progressively).

9. Troubleshooting

10. Charging

Note: The charger indicator is red when charging and green when fully charged.

• Charging Port: Located on the scooter body.
• Charging Port: Located on the scooter body.

11. Maintenance

• Lubrication: Every six months, apply a small amount of white grease or lubricant to the folding parts. Every three months, check the scooter for loose screws and tighten them if necessary.
• Battery: Turn off the power when charging or not in use. Store the scooter in a safe place if not used for an extended period, and charge it at least once every 3 months.
• Storage: Do not leave the scooter in direct sunlight or excessively humid environments for extended periods. Keep it clean.

12. Warranty

If the product exhibits defects or damage within the warranty period from the date of purchase, and after inspection and determination by the KuKirin after-sales service center, you are entitled to free repair, exchange, or return service. When making a claim, please contact the product seller and follow their instructions. You must provide accurate, complete, and valid purchase information or an invoice.

13. Warranty Card

When requesting product repair, please fill out the following information completely and clearly.

Seller Information:

Name: Shenzhen KuKirin Technology Co., Ltd.

Address: 4913, 4th Floor, Hasee Computer Building, Madame Curie Avenue, Wankecheng Community, BanTian Street, LongGang District, ShenZhen City.

Due to continuous product function improvements and design modifications, this manual may not be entirely consistent with the product you purchased. Please refer to the actual product.