2007-08 Toyota Land Cruiser LC200 Wiring Diagram

LVDS and RF Connections

This section details the video signal and antenna connections. The LVDS Outbound Wire (Video Signal) connects to the factory screen and the Hamilton Box. The RF connection is also shown. A BT/Wifi Antenna connects to a white port. These connections are made to the factory screen and factory harness.

Hamilton Interface and Accessory Harness

The Hamilton Interface Main Power Wire (Long Tan) features ports labeled 360 CAM TOUCH, USB, and POWER. Some connections are marked as Not used. The Main Accessory Harness (Short Tan) to Hamilton Box includes connections for Ext MIC, GND, ACC OUT, and Cam Power. Some of these are also marked as Not used.

Factory System Integration

Connections are made to the back of the factory screen and factory radio. The diagram shows a connection for Power to the factory screen. For the factory radio, connections include Audio and Power. There is a specific mention for "For wired CarPlay and system updates".

Mark Levinson Audio System Specifics

Instructions are provided for vehicles equipped with the Mark Levinson audio system. If your LC has a dark blue port on the FACTORY RADIO, connect the Hamilton dark blue connector to the FACTORY RADIO ONLY and leave the factory plug disconnected. Do not connect Hamilton A to B. If your LC has no dark blue Mark Levinson port on the FACTORY RADIO, then connect Hamilton A to B and leave the Hamilton dark blue plug unused. Specifically, connection B is "Connect to A Except for Mark Levinson", and connection A is "Connect to B Except for Mark Levinson".

Default System Operation

The system will utilize the factory microphone and camera by default.

Revision and Contact Information

Revision: 6.25

Contact: support@hamiltonmotorcompany.com | (919) 858-2890