HALO ELECTRIC SCOOTER

In the Box

• Voyager Halo Electric Scooter
• Charging Adapter
• User's Manual with Warranty Information

Scooter Components

Diagram showing the components of the Halo Electric Scooter:

• Front Fork Decoration
• Front Wheel
• Kickstand
• Deck
• Charging Port
• Rear Wheel
• Rear Fender
• Rear Light

Folding the Stem

Fold the stem all the way down until it is securely in place.

Charging

Before riding your scooter, ensure the battery is fully charged. Follow these steps:

1. Ensure the scooter is powered off before charging.
2. Pull the rubber cover off the scooter's charging port.
3. Connect one end of the charging adapter to the scooter's charging port. Plug the other end into a suitable power outlet.
4. The LED light on the charging adapter will be red while charging and turn green when fully charged.
5. Unplug the charging adapter when charging is complete and replace the rubber cover on the charging port.

NOTE: Charging takes approximately 5 hours. To extend battery lifespan, charge at least once every 20-30 days.

LCD Display

The LCD display shows:

• Current Speed
• Battery Level
• Front Light (on/off) indicator
• Power Button
• Units of Measure (miles/kilometers)
• Start Mode
• Speed Gear

Using The Controls

1. Power ON/OFF: Press and hold the power button for approximately 2 seconds.
2. Gear Switch: Tap the power button repeatedly to switch between 3 speed gears: Gear 1 (6 kph / 3 mph max speed), Gear 2 (15 kph / 9 mph max speed), Gear 3 (24 kph / 15 mph max speed).
3. Lighting: Double-tap the power button to turn the front light and rear light (brake light) on or off. The brake light illuminates when braking.
4. Kick Start Mode: Triple-tap the power button to switch from standard mode to kick start mode. In kick start mode, you must kick off and gain speed before using the accelerator.
5. KM/MPH: With the scooter powered off, press and hold the power button for approximately 8-10 seconds to switch between miles and kilometers. Repeat to switch back.
6. Cruise Control Mode: Press the accelerator and brake simultaneously for approximately 3-5 seconds to toggle cruise control. When enabled, the scooter maintains the selected gear's full speed even after releasing the accelerator. Press the brake or accelerator again to slow down.
   

   White = Cruise Control ON
   Green = Cruise Control OFF

Safety Precautions

• Do not ride this scooter under conditions with low visibility.
• Do not carry passengers.