ENERGY STAR RATED DEHUMIDIFIER

Before First Use

To prevent internal damage, keep the unit upright for at least 24 hours before plugging it in.

Important Safety Instructions

General Safety

• Do not exceed the power outlet rating.
• Use the control panel to operate; do not plug/unplug to turn on/off.
• Do not use if the power cord is damaged.
• Do not modify the power cord or share outlets.
• Do not touch the plug with wet hands.
• Do not install near combustible gas or heat sources.
• Disconnect power if unusual sounds, smells, or smoke occur.
• Never attempt to repair the unit yourself.
• Turn off and unplug before cleaning.
• Do not use near flammable gases or combustibles.
• Do not drink or use water drained from the dehumidifier.
• Do not remove the bucket while the unit is operating.
• Avoid using in small or wet spaces.
• Place on a level, sturdy floor.
• Do not cover air intake or exhaust openings.
• Exercise caution with infants, children, the elderly, and those sensitive to humidity.
• Do not use where chemicals are handled.
• Keep fingers and foreign objects out of openings; warn children of dangers.
• Protect the power cord from heavy objects and compression.
• Do not climb on or sit on the dehumidifier.
• Always secure filters and clean them monthly.
• If water enters the unit, turn off, disconnect power, and contact homelabs Customer Service at 1-800-898-3002.
• Do not place water containers on top of the dehumidifier.

Electrical Information

The homelabs nameplate on the rear panel contains electrical and technical data. Ensure proper grounding to minimize shock and fire hazards. Use a properly grounded wall socket. If your socket is not adequately grounded, consult a qualified electrician. Do not use extension cords or adapter plugs. Do not remove any prong from the power cord.

Cautionary Notes

• Children aged 8 and older, and persons with reduced capabilities, can use the dehumidifier with supervision or instruction. Cleaning and maintenance by children require supervision.
• If the supply cord is damaged, contact homelabs Customer Service at 1-800-898-3002 for replacement.
• Disconnect from the power supply before cleaning or maintenance.
• Do not install near combustible gas; accumulation may cause fire.
• If the unit is knocked over, turn off, unplug immediately, and inspect for damage. Contact homelabs Customer Service for repair or replacement if damaged.
• Disconnect power during thunderstorms to prevent lightning damage.
• Route the power cord safely away from traffic areas and under furniture or rugs to prevent tripping or damage.
• Do not operate with a damaged cord or plug; contact homelabs Customer Service.
• Avoid using with solid-state speed control devices to reduce fire or shock risk.
• Install the dehumidifier according to national wiring regulations.
• Contact homelabs Customer Service at 1-800-898-3002 for repair or maintenance.

Parts Description

Front View

• Control Panel: Contains buttons and display for operation.
• Handle: Located on both sides for carrying.
• Panel: The main body of the unit.
• Air Outlet Grille: Where dehumidified air is expelled.
• Air Intake Grille/Air Filter: Where air is drawn into the unit.
• Bucket: Collects condensed water.
• Drain Hose Outlet: Connection point for continuous draining.
• Water Level Window: Allows visual checking of the water level in the bucket.
• Caster: Wheels for mobility (on some models).

Rear View

• Power Cord Buckle: Secures the power cord when not in use.
• Power Cord: Connects the unit to the power outlet.
• Power Plug: The three-prong plug for the wall socket.

Accessories

• Pump Drain Hose (1pc): Included for models with a pump feature.
• Power Cord Buckle (1pc): For securing the power cord.
• Threaded Female End (1pc): For connecting a water hose for continuous draining (on some models).

Operation

Placement

• Ensure the unit is upright for at least 24 hours before initial use, especially if it may have been tilted during shipping.
• The dehumidifier is designed for an operating environment between 41°F (5°C) and 95°F (35°C).
• When using casters, do not force movement over carpet or move the unit with water in the bucket to prevent tipping and spilling.
• Maintain adequate clearance: at least 7.9 inches (20 cm) on the sides and rear, and 15.75 inches (40 cm) in the front for proper airflow.

Smart Functions

• Auto Shut Off: The unit automatically turns off when the water bucket is full or the desired humidity level is reached.
• Wait 3 minutes before resuming operation: To prevent damage, the compressor will not restart immediately after a cycle; it will automatically resume after a 3-minute delay.
• Auto Defrost: If frost builds up on the evaporator coils, the compressor will cycle off, and the fan will continue to run until the frost disappears.
• Auto-Restart: If power is interrupted, the dehumidifier will automatically restart with its previous settings once power is restored.

Control Panel

• POWER Button (⏻): Turns the dehumidifier on and off.
• FILTER Button: The Filter light illuminates after 250 hours of operation as a reminder to clean the air filter. Press the button after cleaning to reset the indicator.
• COMFORT Button: Activates a preset comfortable humidity level. Manual humidity adjustment is disabled in this mode. The target humidity is automatically set based on ambient temperature: 55% RH below 65°F, 50% RH between 65-77°F, and 45% RH above 77°F.
• CONTINUOUS Button: Activates continuous dehumidifying mode. When active, the LEFT/RIGHT buttons are disabled.
• TURBO Button: Controls the fan speed. Select High for maximum moisture removal or Normal for quieter operation.
• LEFT/RIGHT Buttons (< >): Used to set the desired humidity level in 5% increments, from 35% RH to 85% RH. These buttons are only functional when CONTINUOUS MODE is turned off.
• TIMER Button (?): Initiates the Auto Start and Auto Stop features. Press the Timer button when the unit is ON to set Auto Stop (Timer Off light illuminates), or press again to set Auto Start (Timer On light illuminates). Press the Timer button when the unit is OFF to set Auto Start (Timer On light illuminates), or press again to set Auto Stop (Timer Off light illuminates). Use the LEFT/RIGHT buttons to adjust the timer duration in 0.5-hour increments up to 10 hours, then in 1-hour increments up to 24 hours. The control will count down the remaining time. Timer settings register after 5 seconds. Both TIMER ON and OFF lights illuminating indicate both functions are programmed. Setting the timer to 0.0 or turning the unit off/on cancels the Auto Start/Stop function.
• Indicator Lights: Timer ON, Timer OFF, FULL (indicates the water tank is full and needs emptying).
• LED Display: Shows the set humidity level (35-85%) or timer setting (0-24 hours) during adjustment. It then displays the actual room humidity level (30-90% RH with ±5% accuracy).

Error and Protection Codes

• Error Codes: AS (Humidity sensor error), ES (Temperature sensor error), E3 (Dehumidifier malfunction).
• Protection Codes: P2 (Bucket is full or not in the correct position). Empty the bucket or ensure it is properly seated.

Removing Collected Water

• 1. Use the bucket: Remove and empty the bucket when it is full. Note: Do not use this method when the outdoor temperature is 32°F (0°C) or below, as water may freeze and block the unit.
• 2. Continuous draining: Attach a water hose (with a female threaded end, if applicable) to the drain hose outlet. Ensure a tight connection. Route the hose downhill to a floor drain or suitable drainage facility. Remove the hose when the continuous drain feature is not in use.

Care & Cleaning

Cleaning the Dehumidifier

• WARNING: Turn the dehumidifier off and unplug it from the wall outlet before cleaning.
• Clean the bucket: Clean the bucket with water every two weeks.
• Clean the air filter: Clean the filter with potable water at least once every 30 days. CAUTION: Do not operate the dehumidifier without a filter, as dirt and lint can clog it and reduce performance.

Storing the Dehumidifier

• When not using the dehumidifier for extended periods:
• After turning off, wait one day before emptying the bucket.
• Clean the main unit, bucket, and air filter.
• Wrap and bundle the power cord.
• Cover the dehumidifier with a plastic bag.
• Store the unit upright in a dry, well-ventilated place.

Troubleshooting

Before contacting homelabs customer service, review this list for common issues.

If the dehumidifier operates abnormally or does not operate, and the solutions above are not helpful, please contact homelabs Customer Service at 1-800-898-3002.

Warranty

homelabs offers a limited two-year warranty on products purchased new and unused from homelabs Technologies, LLC or an authorized reseller, with an original proof of purchase. The warranty covers defects arising from faulty manufacture, parts, or workmanship during the warranty period.

Exclusions

• Normal wear and tear.
• Abuse, mishandling, accident, or failure to follow operating instructions.
• Exposure to liquid or infiltration of foreign particles.
• Servicing or modifications by parties other than homelabs.
• Commercial or non-household use.

Claim Process

• A receipt indicating the purchase date is required for any claim. Keep all receipts in a safe place.
• Product registration on homelabs.com/reg is recommended but not required to activate the warranty.
• The warranty is void if repairs are attempted by non-authorized third parties or if non-homelabs spare parts are used.

Contact for Service

For any issues, contact homelabs Customer Service at 1-800-898-3002. Service after the warranty expires is available at an additional cost. This warranty provides specific legal rights, and customers may have other rights that vary by state, country, or province.

Warnings

General Warning

• WARNING: Keep all plastic bags away from children.

State of California Proposition 65 Warnings

• WARNING: THIS PRODUCT COULD CONTAIN ONE OR MORE CHEMICALS WHICH ARE KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.

Manufacturer, distributor, importer, and seller are not liable for ANY damage caused by improper use, storage, care, or failure to follow warnings associated with this product.

Contact Us

• Chat: homelabs.com/chat
• Call: 1-(800)-898-3002
• Email: help@homelabs.com