GE Profile™ Series 30" Built-In Touch Control Induction Cooktop

Dimensions and Installation Information

Important: Requires a 5" free area between the bottom of the cooktop and any combustible material, such as shelving. This free area is not required when installing a wall oven underneath the cooktop. Refer to installation instructions for details. Requires a 15" minimum clearance from the cooktop to adjacent overhead cabinets. Units are supplied with a 48" flexible armored cable.

Note: 30" induction cooktops are approved for use over select GE 27" and GE 30" Single Wall Ovens and Warming Drawers. Consult the cooktop and wall oven/warming drawer installation instructions packed with the product for current dimensional data. If installed with a GE Telescopic Downdraft System, consult both the cooktop and downdraft installation instructions packed with the product before installing. The cooktop's gas/electric supply may need to be re-routed to install the downdraft. The countertop cutout requires a minimum of 23-1/2" flat countertop surface and a minimum of 25" total countertop depth. Additionally, other clearances to the front edge of the countertop must be considered. Before installing, consult the installation instructions packed with the product for current dimensional data.

Cutout filler trim kit: A filler trim kit is available for use if your countertop cutout is larger than the dimensions shown, up to 29-13/16" x 20-7/16". To reduce the cutout opening for installation of this cooktop, order JXTR32B for black or JXTR32W for white. These kits may be ordered from your GE Dealer.

Approximate Cooking Dimensions:

• 4-5/8" at baffle near center of unit (except when installed above an approved wall oven)
• 3-1/4" at rear of air intake
• 1-3/4" MIN. to rear wall
• 29-3/4" width
• 19-1/4" depth
• 2-1/2" MIN. required
• 28-1/2" to 28-5/8" width
• 19-5/8" depth
• 13" MAX. depth of unprotected overhead cabinets (when no hood or microwave is installed)
• 30" MIN. from countertop to unprotected cabinet (when no hood or microwave is installed)
• 15" MIN. height from countertop to nearest cabinet (including light rails) on both sides of cooktop
• Electrical junction box 16" MIN. below countertop
• 2" MIN. clearance to side wall from cut-out on both sides of cooktop

Power Ratings:

*Note: Check local codes for required breaker size.

Features and Benefits

• Four Induction elements: Enjoy a new level of rapid, precise heating with a cool-to-the-touch surface that's easy to clean.
• Digital touch controls: Accurately control your heating and enjoy an easy-to-clean surface.
• 11" 3,700-watt induction element: Rapidly boil water with GE's most powerful induction element.
• SyncBurners: Control two 7" elements simultaneously to evenly heat large cookware or griddles.
• Kitchen timer: Helps coordinate meal preparation and cooking.
• Control lock capability: Protects against unintended activation.
• Pan presence & size sensor: Cook efficiently with elements that heat to the size of your pan and shut off when no pan is present.
• Red LED display with black glass surface: Achieve a modern look that complements the entire kitchen.
• Hot surface indicator lights: Know when elements are too hot to touch with a quick glance.
• Model: PHP9030DJBB - Black on black

Optional Stainless Steel Clad Aluminum Griddle: Achieve even results with this lightweight griddle, tailored to fit GE SyncBurners. Order part number JXGRIDL1 from your GE Dealer.