Eureka! Timberline SQ Vestibule Accessory
FOR LIFE OUTDOORS.
Installation Steps
Step 1: Begin with your tent already set up and staked.
Diagram Description: The image shows a Eureka! tent fully erected and secured to the ground.
Step 2: Push the top web through the center of the shock cord. Wrap it up and over the black hub. Secure with the toggle.
Diagram Description: A close-up view illustrates the top web of the vestibule being passed through the central shock cord and black hub of the tent's pole structure, then fastened with a toggle.
Step 3: Hang the J-Hook onto the web loop near the end of the ridge pole extension.
Diagram Description: A J-shaped hook, part of the vestibule, is being attached to a loop located at the extremity of the tent's main ridge pole.
Step 4: There are a pair of Velcro® tabs on each side of the vestibule. Wrap them around the tent pole.
Diagram Description: A detailed view shows Velcro® tabs situated on the sides of the vestibule being wrapped around the tent pole for secure attachment.
Step 5: The vestibule and tent webs share the same pole. Lift the pole and fit the vestibule grommet underneath the tent grommet.
Diagram Description: The tent pole is lifted, and a grommet on the vestibule is positioned directly beneath the corresponding grommet on the tent.
Step 6: Pull out and stake down the two front web loops. Restake the "Wings" and Your Vestibule is Ready!
Diagram Description: The two front web loops of the vestibule are extended and staked into the ground. The side "wings" of the vestibule are also restaked, signifying the completion of the installation.
Note: It's easier to install the vestibule if you release the "wings" from their stakes and fold them back over the poles.
