Pelonis Turbo Fan Heater

Important Safety Instructions

Please read and save these important safety instructions. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surface. If provided, always use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use the heater outdoors.
7. This heater is not intended for use in bathroom, laundry areas and similar moist indoor locations. Never locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
9. ⚠️ CAUTION: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. To do so could result in an electric shock hazard.
10. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
11. ⚠️ CAUTION: It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
12. To disconnect the heater, first turn controls to off, then remove plug from outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surface, like a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
17. ⚠️ CAUTION: Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or reloadable power tap (outlet/power strip).
18. The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.
19. Disposal of oil contained within should be in accordance with applicable regional, national, and local laws and regulations.
20. In order to avoid overheating, do not cover the heater.
21. ⚠️ CAUTION: To prevent electric shock, match wide blade of plug to wide slot and fully insert.
22. "SAVE THESE INSTRUCTIONS"

Operating Instructions

The heater features a pilot light, a safety grill covering the fan, and a power selection knob.

Placement: Place the heater on a flat, stable surface. An uneven surface may cause the turnover switch to activate abnormally, preventing the heater from working. Ensure the surface below the heater's base is flat.

Power Switch Knob: Turn the Power selection knob to select between 4 functions: (Heat) 900W LOW, (Heat) 1500W HIGH, (Fan) LOW, (Fan) HIGH.

Turning Off the Heater:
A. Turn the Power Switch Knob to the OFF position.
B. Remove the power plug. Store the heater after the entire machine has become cool.

Safety Protection

1. Overheat Protection: This heater includes an Overheat Protection System that shuts the unit off if it overheats due to abnormal conditions. If this occurs, turn the heater "OFF", unplug it, inspect and remove any objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and resume normal operation.
2. Inversion Protection: When the whole heater is inverted, the safety system will automatically cut off the power. The heater will return to its previous working state after the body is placed upright.

Additional Features

• Convenient Carry Handle – allows for easy transport from room to room.

Troubleshooting

If your heater fails to operate, please follow these instructions:

• Ensure that your circuit breaker or fuse is working properly.
• Be sure the heater is plugged in and that the electrical outlet is working properly.
• Check for any obstruction. If you find any obstruction, turn the heater "OFF". Unplug the heater and wait a few minutes for it to cool down. Carefully remove the obstruction. Plug the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS.

NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING TO THE SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.

Cleaning and Storage

It is recommended that the heater be cleaned at least one time during the operating season to provide optimum performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Save the box for off-season storage.

• Turn the heater "OFF", unplug it, and wait for it to cool down.
• Use a dry cloth to clean only external surfaces of the heater.
• Do not use any cleaning agents or detergents.
• Never immerse the heater in water.
• Pack the heater in the original carton and store it in a cool and dry place.

Specifications

Model No.:

NF-0017

Voltage:

120V, 60Hz

Current:

Maximum continuous draw: 12.5 Amps.

Output:

5200 BTUs

Power:

LO = 900 Watts, HI = 1500 Watts

Tolerances on all specifications: Not exceeded than 105%.

Service & Support

In the event of a warranty claim or if service is required for this heater, please contact Pelonis at the following:

For questions or comments, please write to:

For your records, staple your sales receipt to this manual and record the following:

DATE OF PURCHASE: ________________________________

PLACE OF PURCHASE: ________________________________

[STAPLE SALES RECEIPT HERE]

NOTE: PROOF OF PURCHASE IS REQUIRED FOR ALL WARRANTY CLAIMS.

PRINTED IN CHINA