Diagram and Parts List
The following parts are included for installation:
- Faucet Body
- Waterproof Rubber Ring
- Threaded Metal Pipe
- Rubber Gasket
- Metal Gasket
- Mounting Nut
- Screws (x2)
- Red Hose (hot water)
- Blue Hose (cold water)
Installation Steps
STEP 1: Installing the faucet assembly.
Place the Waterproof Rubber Ring onto the Threaded Metal Pipe. Then, insert the Faucet Body onto the pipe.
STEP 2: Connect the Hot, Cold water hoses, and tighten them clockwise.
Connect the Red Hose (hot water) and the Blue Hose (cold water) to the appropriate fittings on the faucet assembly. Tighten clockwise.
STEP 3: Install the faucet to the countertop.
Insert the faucet assembly through the countertop. The recommended hole size is between 1.38 inches (35mm) minimum and 1.5 inches (38mm) maximum.
STEP 4: Install gaskets, nut and fasten the screws.
From underneath the countertop, place the Rubber Gasket, followed by the Metal Gasket, onto the Threaded Metal Pipe. Screw the Mounting Nut onto the pipe and then fasten the two Screws into the mounting bracket.
STEP 5: Fasten the screws with the screwdriver.
Use a screwdriver to securely tighten the two screws, ensuring the faucet is firmly attached to the countertop.
STEP 6: Connect the Hot, Cold water supply.
Connect the Red Hose (hot water) to the hot water supply valve and the Blue Hose (cold water) to the cold water supply valve. Ensure connections are secure.
STEP 7: Turn the faucet on and check for leaks.
Open the water supply valves and turn the faucet handle to test water flow and check all connections for any leaks.
