Anslut Decklights LED

Safety Instructions

Read the instructions carefully before use! Save them for future reference.

• Do not connect the product to the mains while still in the pack.
• Only intended for outdoor use.
• Only use the product together with the supplied LED light sources.
• The LED light sources cannot be replaced.
• Check that no light sources are damaged.
• No parts of the product can be replaced, or repaired. The whole product must be discarded if any part is damaged.
• Do not use sharp or pointed objects during installation.
• The electrical installation should be carried out by an authorised electrician in compliance with national regulations.
• Do not subject the power cord or wires to mechanical stress.
• This is not a toy. Be careful if using the product near children.
• Disconnect the transformer from the power point when the product is not in use.
• This product must only be used together with the supplied transformer and must never be connected directly to the mains supply without a transformer.
• Connect the LED light sources to the transformer before connecting the transformer to the mains, otherwise the LED light sources can be damaged.
• Only use the supplied mains adapter. Do not dismantle the product or attempt to modify, or repair it.
• Never cover the mains adapter – fire risk.
• The product is not intended to be used as general lighting.
• Recycle the product when it has reached the end of its useful life in accordance with local regulations.

Symbols

• ? Read the instructions.
• ? For outdoor use.
• ?️ Safety class III.
• ✅ Approved in accordance with the relevant directives.
• ♻️ Recycle discarded product in accordance with local regulations.

Description

Diagram 1 shows the dimensions of a single LED deck light: outer diameter 45mm, inner recess diameter 30.5mm, height 26mm.

Diagram 2 illustrates the lights installed in a paved outdoor area, surrounded by gravel and vegetation.

Technical Data

Installation

Diagram 3 indicates the required hole diameter for installation is 32mm.

Diagram 4 shows an LED deck light being inserted into a pre-cut hole, secured by spring clips.

Interconnection

Diagram 5 shows the wiring: the LED light connects to the transformer, which is then connected to a DC 12V power source. The diagram labels are 'To light' and 'DC 12V'.

Diagram 6 illustrates the complete system setup. It includes a transformer, cables of 1.2m and 1m, connectors, and 10 LED lights. A separate 1x cable with connectors is also shown.

Maintenance

Clean the product with a soft cloth, moistened with a mild detergent.