Razor

Step 1

Remove the flag and use a 5 mm Allen wrench to remove four (4) screws on the seat, then remove the seat.

Step 2

Use a Phillips screwdriver to remove five (5) screws on the battery rear cover.

Step 3

Use a Phillips screwdriver to remove three (3) screws on the battery front cover. Then remove the battery front cover after unplugging all plugs.

Step 4

Using a Phillips screwdriver, remove the screws from the chain cover and remove the cover.

Step 5

Using two (2) 17 mm Socket wrenches, loosen and remove the lock nuts from the rear wheels.

Step 6

Remove the wheels and hardware from the axle and set aside.

Step 7

Use a 5 mm Allen wrench and a 10 mm open-end wrench to remove two (2) bolts and lock nuts from the brake drum.

Step 8

Use a 3 mm Allen wrench to remove the set screw on the brake hub. Slide the brake drum and brake hub off from the axle.

Step 9

Using long needle pliers, remove the master link from the chain and remove the chain.

Step 10

Use a 3 mm Allen wrench to remove the set screw from the sprocket and slide it out from the axle.

Step 11

Use C clip pliers to take off the snap rings on both sides.

Step 12

Remove the rear axle from the frame.

Step 13

To install a new rear axle, reverse steps 1 through 12.

ATTENTION: Charge battery 8 hours before using.