Important Safety Information
⚠️ WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Required Tool (Not included)
- ? Phillips screwdriver
Replacement Procedure
Step 1: Remove Rear Battery Cover
Using a Phillips screwdriver, remove the five (5) screws from the rear battery cover. Set the cover aside.
Diagram Description: The diagram shows the rear of the scooter base. A Phillips screwdriver is depicted removing screws (labeled 'A') from a rectangular battery cover. Arrows indicate the direction of screw removal. Two connection points are labeled 'B'.
Step 2: Remove Controller Screws
Using a Phillips screwdriver, remove the two (2) screws from the controller.
Diagram Description: The diagram shows a close-up view of the controller unit. A Phillips screwdriver is depicted removing two screws (labeled 'A') that secure the controller. Various wires are shown connected to the controller.
Step 3: Unplug and Remove Controller
Unplug all of the connectors from the controller and remove the controller unit.
Diagram Description: This diagram illustrates unplugging multiple wire connectors from the controller unit. The controller is then shown being detached from its mounting.
Step 4: Install New Controller
Install the new controller, then reverse steps 1 through 3.
Note: Make sure the two red wires that connect to the power switch connect to the two silver prongs on the new controller. The gold-colored prong is only for the black wire from the charger port.
ATTENTION: Charge battery 12 hours before using.
Support
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
