8BitDo Ultimate C Bluetooth Controller
Controller Layout
The controller features a standard layout with two analog sticks, a D-pad, face buttons (A, B, X, Y), shoulder buttons (L, R, ZL, ZR), home button, screenshot button, and pair button.
Top View: Shows the analog sticks, D-pad, face buttons, and shoulder buttons.
Bottom View: Shows the triggers (L2, R2) and the USB-C port.
Indicator Lights: Power LED and Status LED indicate the controller's status.
Power On: Press the home button.
Power Off: Hold the home button for 3 seconds.
Force Power Off: Hold the home button for 8 seconds.
Switch Connection
System Requirements
Requires Switch system version 3.0.0 or above. NFC scanning, IR camera, HD rumble, and notification LED are not supported.
Bluetooth Connection
- Press the home button to turn on the controller.
- Hold the pairing button for approximately 3 seconds until the status LED blinks rapidly, entering pairing mode. (This is only required for the first-time connection.)
- On your Switch console, go to Settings > Controllers and Sensors > Change Grip/Order and wait for the controller to connect.
- The status LED will remain solid when the connection is successful.
Wired Connection
Ensure that "Pro Controller Wired Communication" is enabled in the system settings. Connect the controller to the Switch via a USB cable. The controller will be recognized by the system for gameplay.
Battery Information
The controller is equipped with a 480 mAh rechargeable lithium battery, providing approximately 16 hours of playtime. Charging time is about 2 hours.
Battery Status Indicators:
- Low Battery: Red LED blinks.
- Charging: Red LED stays solid.
- Fully Charged: Red LED turns off.
The controller will automatically shut down if there is no connection within 1 minute after startup or no activity within 15 minutes after connection. The controller will not shut down when connected via a wired connection.
Support
For further information and additional support, please visit support.8bitdo.com.
