Yaheetech Portable Massage Table (Model 610920)
Important Information & Safety
Please read this instruction manual carefully before attempting to install.
Installation Recommendations:
- We recommend 1 or more people for installation.
- The expected assembly time is approximately 0.5 hours.
- This product is not intended for use by children.
- Keep the product away from fire or other heat sources.
- We recommend wearing protective gloves during assembly.
Assembly Precautions:
Please follow the instruction manuals and use a pad to avoid damage during assembly. [Illustration shows a person unpacking a box labeled 'CARTON'. Illustration shows a person discarding an item into a bin, marked with a red cross symbol [❌], indicating it should not be discarded this way. Illustration shows a person assembling a structure, marked with a checkmark symbol [✔️], indicating correct assembly.]
Parts List
The following parts are included:
- Part 1: Massage Bed (x1)
- Part 2: Headrest Assembly (x1)
- Part 3: Armrests (x2)
- Part 4: Face Cradle (x1)
- Part 5: Hanging Armrest Strap (x1)
Maximum User Weight: 102 kg / 220 lb.
Assembly Instructions
Step 1: Unpack and Unfold
Unwrap and unfold the massage bed. Take out all parts from inside the bed.
Step 2: Prepare Armrests
Pull out the metal bars located at the bottom of the armrests (Part 3). Set these bars at a right angle to the armrest.
Step 3: Attach Armrests
Insert the prepared metal bars of the armrests (Part 3) into the two side holes located near the front of the massage bed.
Step 4: Attach Headrest
Unfold the headrest assembly (Part 2) and fix its bars. Insert these bars into the two holes at the front of the massage bed.
Step 5: Secure Hanging Armrest
Thread the straps of the hanging armrest (Part 5) through the middle bar of the headrest assembly (Part 2). Fasten and adjust the straps until they are level.
Step 6: Connect Face Cradle
Assemble the face cradle (Part 4) to the headrest assembly (Part 2) using the attached hook and loop fasteners.
Step 7: Adjust Headrest Angle
The angle of the headrest assembly (Part 2) is adjustable. Before adjusting, release the side fastener of Part 2. Please adjust the angle gently and avoid excessive force.
Support and Further Information
If you are not entirely satisfied with your purchase, please follow these steps to contact the seller:
- Go to Your Orders.
- Find your order in the list.
- Select "Problem with order".
- Choose your topic from the displayed list.
- Select "Contact seller".
You can also download the electronic Installation Manual from the "Product guides and documents" section of the advertising page.
Manufacturer: Made in PRC for Yahee GmbH
Importer: Yahee GmbH, Hans-Grüninger-Weg 11, 71706 Markgröningen
