Instruction Manual

Customer Service (North America)

Tel: 1.310.533.3800 | Tel: 1.800.323.5565 (English and Spanish)

Fax: 1.310.533.3899

Monday through Friday 9:00 am - 4:30 pm (Pacific Time)

English Support: support@sevilleclassics.com

Seville Classics, Inc.
Torrance, CA 90501 USA
www.sevilleclassics.com
©2020 Seville Classics, Inc.

Parts List

A. GloGlobe®

B. Charging Base (1)

C. Adapter (1)

D. Remote Control (1)

Unpack and remove all parts from the box. If there are missing or broken parts, please contact CUSTOMER SERVICE.

Specifications

• 8 - 12 hours of single-color operation
• 16 LED color options (with dimmer)
• IPX7 Waterproof Rating
• 4 Modes (flash/strobe/fade/smooth)
• 24-key remote control
• Stainless-steel hanger
• Wireless rechargeable lithium-ion battery

Features

• Adapter: Input 100-240V 50/60Hz, Output 7.5 V-0.6 A
• 12 RGB + 6 White LEDs
• Rechargeable lithium-ion battery 3.7V 2000mAh
• Charging time: 7 to 9 hours
• 8 to 12 hours of operation
• IR remote control range: 13 feet (4 meters)

Warnings

• This is not a toy; keep out of the reach of children.
• Keep this product away from chemicals or high heat.
• Regarding the adapter (Part C) and charging base (Part B):
• Only use the adapter and charging base to charge the battery of the GloGlobe® (Part A).
• The adapter and charging base should not be used outdoors or exposed to rain, humidity, liquids, or heat.
• Keep the adapter and charging base out of reach of children.
• Disconnect the adapter from power when not in use.
• Never attempt to open the adapter or the charging base.
• Keep the remote control away from water, liquids, and heat.
• Do not put the GloGlobe® on the water if damage/crack is found.
• Never throw the GloGlobe® into the pool. Place the product onto the water gently.
• Take the GloGlobe® out of the pool when not in use.
• Never jump, sit, or stand on the product.

CAUTION: To avoid the risk of electric shock or a damaged product, wipe the light until dry before charging.

GloGlobe® Lithium-ion Battery Care

For long-lasting care and maintenance of the built-in GloGlobe® battery, please charge and operate in the following conditions:

GloGlobe® Charging Temperature: 32-113 °F (0-45 °C). Charging the GloGlobe® at a very low temperature will lower the capacity and reduce cycle life of the battery.

GloGlobe® Use/Storage Temperature: 14-113 °F (-10-45 °C). Keeping the battery charged protects circuits when stored for longer than three months.

EU Plug Adapter Attachment/Removal

Attaching adapter: Align the adapter's tabs with the slots on the charging base. Twist the adapter clockwise to lock it into place.

Removing adapter: Align the adapter's tabs with the slots on the charging base. Twist the adapter counter-clockwise and pull to release.

UK Plug Adapter Attachment/Removal

Attaching adapter: Align the adapter's tabs with the slots on the charging base. Twist the adapter clockwise to lock it into place.

Removing adapter: Align the adapter's tabs with the slots on the charging base. Twist the adapter counter-clockwise and pull to release.

Charging Instructions

1. Please ensure GloGlobe® is fully charged before first use.
2. Place the charging base on a dry and level surface.
3. Use a clean and dry cloth to clean the surface of the charging base and the bottom of the GloGlobe®.
4. Insert the adapter into the socket on the side of the charging base (PHOTO 1).
5. Connect the adapter to the electrical outlet.
6. The indicator light on the charging base will turn green when connected.
7. Place the GloGlobe® on the base. The indicator light will turn red while charging.
8. The indicator light will turn green when the battery is fully charged.
9. After charging, disconnect the adapter from the outlet and remove the GloGlobe® from the charging base.

PHOTO 1 shows the charging base with the adapter plugged in. PHOTO 2 shows the remote control. PHOTO 3 highlights the LED module, hanger, screws, and the On/Off/Mode button.

Remote Control Instructions

Note: Before using the remote control for the first time, remove the plastic sheet from the battery cover and discard.

Turn GloGlobe® On/Off: Use the ON/OFF buttons on the remote.

Brightness/Speed Adjustment:

• Brighten/Increase Speed: Increases brightness in single-color mode or increases color change speed in multi-color mode.
• Dim/Reduce Speed: Reduces brightness in single-color mode or reduces color change speed in multi-color mode.

Single Color Mode

Choose from 16 solid colors, including white, using the color selection buttons on the remote.

Multi-Color Modes

• FLASH: Colors flash red, green, and blue.
• STROBE: 7 colors flash.
• FADE: Colors fade from one to the next through all 16 colors. This mode has the shortest run time.
• SMOOTH: Colors slowly transition through red, green, and blue. This mode has the longest run time.

Manual Operation

• To operate GloGlobe® without the remote control, press and hold the On/Off/Mode button (PHOTO 3) for 3 seconds to turn on. Press and hold for 3 seconds to turn off.
• When GloGlobe® is first turned on by remote control, it will default to the last setting used. When turned on by the On/Off/Mode button, it will default to the FADE option. Push the On/Off/Mode button to cycle through the 4 modes (flash/strobe/fade/smooth).
• Use the stainless-steel hanger to hang GloGlobe® (PHOTO 3).

Troubleshooting

Problem: Remote control is not functioning.

Solution:

• The small plastic sheet on the battery cover was not removed. Remove it to activate the remote.
• The remote control battery is dead. Remove and replace it with a new one. Note the polarity of the battery on the cover and the direction when installing the new battery in the remote control.

Problem: Water is inside of GloGlobe™

Solution:

• Carefully remove all screws and washers (PHOTO 3). Set aside in a safe place.
• Remove LED module (PHOTO 3) from outer housing. DO NOT OPEN LED module.
• Drain all water from outer housing. Wipe the inside of GloGlobe® and the outside of the LED module dry with a cloth.
• When reinstalling the LED module, tighten the screw opposite the last one tightened in a criss-cross pattern. Do not fully tighten screws until all are partially installed.
• Screws should be tightened with a maximum torque of 2.65 lbs./1.2 kgs.

Problem: GloGlobe™ turns off too quickly.

Solution:

• Reduce brightness. Operation time depends on the setting being used. Full brightness will cause operation time to decrease.
• Fully charge GloGlobe® before using. The indicator light will turn green when GloGlobe® is fully charged.
• Operation time slowly degrades with each use, which is standard for lithium-ion batteries.

Maintenance and Care

• DO NOT fully submerge into water.
• Always turn off after each use.
• Store indoors when not in use.
• Store out of the reach of children.
• Clean with soap and water.

Remote Control Battery Replacement

If the remote control doesn't activate the light, replace the battery (CR2025).

Back of Remote:

• Press the tab on the side of the battery cover and slide it out of the remote control.
• Exchange the battery. Pay attention to the polarity shown on the battery cover to ensure proper operation.
• The remote control requires a single CR2025 button battery for operation (included).
• It is recommended that the batteries be removed if the remote is not in use for an extended time.
• Install the 1-piece button battery as shown.

(Diagram showing PUSH TAB IN and PULL OUT to RELEASE)

Remote Control Battery Warning

• This product contains a button battery. If swallowed, it could cause severe injury or death in just 2 hours. Seek medical attention immediately.
• Clean battery contacts and those of the devices prior to battery installation if the product is left unused for a long time.
• Dispose of used button batteries immediately and safely. Used button batteries can still be dangerous.
• Tell others about the risks associated with button batteries and how to keep their children safe.
• Make sure the battery is inserted correctly to avoid a short-circuit.

Keep Batteries Out of Reach of Children

• If swallowed, these batteries can cause serious or fatal injuries in less than two hours due to chemical burns and potential perforation of the esophagus.
• If you suspect your child has swallowed or inserted a button battery, seek immediate urgent medical assistance.
• Examine devices and ensure the battery compartment is correctly secured, e.g., that the screw or other mechanical fastener is tightened. Do not use if the compartment is not secured.
• Dispose of used button batteries immediately and safely. Discharged batteries can still be dangerous. Inform others about the risks associated with button batteries and how to keep their children safe.
• Clean the battery contacts and device contacts before installing batteries if the product has not been used for a long period.

This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.