Seville Classics ULTRASlimline Tower Fan - Instruction Manual
1 Year Limited Warranty
Seville Classics, Inc. warrants this product to be free from defects in materials and workmanship for a period of 1 year from the date of purchase. This warranty applies only to the original purchaser and is valid for normal use. For warranty claims, please contact Seville Classics, Inc. Customer Service. The warranty does not apply to products that have been misused, abused, or altered. Seville Classics, Inc. reserves the right to make the final decision on warranty claims.
Contact Information:
Seville Classics, Inc.
19401 South Harborgate Way, Torrance, CA 90501-1322 U.S.A.
Toll Free: 1-800-323-5565
Phone: (310) 533-3800
Fax: (310) 533-3899
Email: support@sevilleclassics.com
Website: www.sevilleclassics.com
Product Information
Model: 10119PB (with remote control)
Voltage: 120V AC
Frequency: 60 Hz
Current: 0.6 A
Please read and save these instructions. © 2019 Seville Classics Inc.
Important Safety Instructions
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury.
- Use this fan only as directed in this manual.
- This fan is intended for personal use INDOORS only.
- Do NOT place the fan near a window or expose it to direct sunlight or moisture.
- Operate the fan on a dry, level surface.
- This appliance has a polarized plug. If the plug does not fit an outlet, try reversing it or contact a qualified electrician.
- Always turn the fan OFF and unplug it before transporting or cleaning.
- When disconnecting, grip the plug firmly and pull from the outlet. Never pull by the cord.
- Do NOT operate the fan if the cord or plug is damaged, or if the unit is malfunctioning.
- Do NOT operate the fan in the presence of flammable or explosive fumes.
- Do NOT place the fan near open flames, cooking appliances, or heaters.
- Do NOT operate the fan if the housing has been removed or damaged.
- Avoid contact with fan's moving parts.
- Close supervision is necessary when the fan is used near children.
- Do NOT mount the fan on a wall or hang it from the ceiling.
- Use of attachments is not recommended.
- This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a person responsible for their safety.
- Do not operate any fan with a damaged cord or plug. Discard or return for examination/repair.
- Do not run the cord under carpeting or cover it with rugs. Do not route the cord under furniture or appliances. Keep the cord away from traffic areas.
Features a Fuse Safety Plug
This product has overload protection (fuse). If the fuse blows, unplug the product, replace the fuse with the correct rating (5 Amp, 125 Volt), and check the product. If the replacement fuse blows, a short-circuit may be present, and the product should be discarded or returned for examination/repair.
User Servicing Instructions (Fuse Replacement)
- Always unplug the product before replacing fuses.
- Grasp the plug and remove it from the outlet.
- Open the fuse cover by sliding it open.
- Carefully remove the fuse using a small screwdriver.
- Insert a new 5 Amp, 125 Volt fuse.
- Close the fuse cover.
CAUTION: Risk of fire. Replace fuse only with a 5 Amp, 125 Volt fuse. Do not replace the attachment plug.
Parts List
- A: FAN-Body
- B: BASE-Front
- C: BASE-Back
- D: Fan-Body SCREWS (Gold Screws)
- E: Remote Control
Fan Assembly
STEP 1
Turn the base upside down. Lock the BASE-front (B) onto the BASE-back (C) by aligning the four holes onto the four posts. Suggestion: Place the top of the fan into the foam packing block from the box to secure it while attaching the base.
STEP 2
Remove the 4 Fan-Body SCREWS (D) from the center post on the bottom of the FAN-Body (A).
STEP 3
Pass the Power Cord through the center hole of the BASE. Align the BASE front (B) with the FAN front (A) and insert the four posts on the FAN body into the four holes on the top of the BASE. Place the 4 Fan-Body SCREWS (D) into the holes through the bottom of the base and securely tighten.
STEP 4
Run the power cord through the guide on the bottom of the BASE-back (C) by tucking the cord under the tabs. Set the fan upright on the base. It is now ready for use.
Control Panel Functions
ON/OFF
Turns the fan ON & OFF.
Speed Selection
Allows four different speed settings: ECO, Low, Medium, High. Note: For ECO speed to run efficiently, it begins at low and automatically drops to ECO.
Timing Selection
There are 15 settings in 1/2 hour increments, from 0.5 hr up to a maximum of 7.5 hours. The LED Indicators (0.5h, 1h, 2h, 4h) show the total time period.
Wind Mode
Allows selection of different wind modes:
- Normal Wind: Operates at the selected speed setting (ECO, Low, Medium, High).
- Sleeping Wind: Gradually lowers the speed from the selected setting down to ECO over time, simulating a gentle breeze.
- ECO Sleeping Wind: Airflow remains at ECO.
- Low Sleeping Wind: Airflow starts at Low for 0.5 hr, then drops to ECO.
- Medium Sleeping Wind: Airflow starts at Medium for 0.5 hr, then drops to Low for 0.5 hr, then drops to ECO.
- High Sleeping Wind: Airflow starts at High for 0.5 hr, then drops to Medium for 0.5 hr, then to Low for 0.5 hr, and finally drops to ECO.
- Natural Wind: Randomly selects wind speeds, simulating outdoor breezes. The following modes are available:
- ECO Natural Wind: Primarily uses ECO speed.
- Low Natural Wind: Primarily uses Low speed.
- Medium Natural Wind: Primarily uses Medium speed.
- High Natural Wind: Primarily uses High speed.
Oscillating Selection
Starts & stops the oscillation of the fan. To change the oscillation angle, manually turn the fan body left or right. There are 5 positions. Full oscillation is achieved in the third (center) position.
Remote Control
Point the remote control's top end directly at the front of the fan, aiming at the small window below the control panel. The remote operates on one CR2032 3V lithium battery (not included). It is recommended to remove the battery if the remote will not be used for an extended period.
- Power Button: Turns fan ON and OFF.
- Speed Mode: Changes wind speed (Low, Medium, High, ECO).
- Wind Mode: Changes the wind mode (Normal, Natural, Sleeping).
- Timer: Sets the fan's operating time from 0.5 hr to 7.5 hr in 0.5 hr increments.
- Oscillation: Turns the fan oscillation ON or OFF.
Storage & Cleaning Instructions
- Turn OFF and UNPLUG the fan before cleaning.
- Use a soft cloth to wipe the housing. Do NOT use water, gasoline, polish, or chemical solutions. Do NOT immerse the fan in water or liquid.
- Use a vacuum cleaner with a narrow hose attachment or brush attachment to clean intake and exhaust vents.
- DO NOT attempt to take the fan apart.
- For a deep clean, use compressed air outdoors.
- Store in a dry place away from excessive heat and direct sunlight.
Customer Service
For questions, comments, or suggestions, please contact Seville Classics Inc. at support@sevilleclassics.com or call (800) 323-5565 or (310) 533-3800 during business hours (9:00 AM - 4:30 PM Pacific Time, Monday to Friday). Register your ULTRASlimline™ Tower Fan at www.sevilleclassics.com/fan for promotions and new product information. For parts and accessories, visit www.sevilleclassics.com.
Proof of Purchase
Please fill out the information below and forward this form along with a copy of your original receipt to:
Seville Classics, Inc.
19401 South Harborgate Way
Torrance, CA 90501 - 1322
U.S.A.
Name: _________________________ (First) _______________ (Last)
Address: _________________________________________________________
City: _________________________ State: ___________ Zip: ___________
Phone Number: __________________ E-mail: _________________________
Place of Purchase: __________________ Date: _______________
FCC Compliance
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. The user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
