Seville Classics ULTRASlimline 4-Speed Tower Fan

Assembly Instructions

Parts List

• A: FAN-Body
• B: BASE-Front
• C: BASE-Back
• D: Fan-Body SCREWS (Gold Screws)
• E: Base SCREWS and CLIPS (White Clips)
• F: Remote Control

STEP 1: Assemble the Base

Turn the base upside down. Unscrew the 2 base SCREWS and base CLIPS from the posts on the BASE-back. Firmly snap the BASE-front onto the BASE-back by aligning the four holes onto the four posts. Replace the SCREWS and CLIPS so that the clips wrap over the BASE-back and tighten.

STEP 2: Attach Fan Body to Base

Remove the 4 SCREWS from the center post on the bottom of the FAN-body.

STEP 3: Secure Fan Body

Pass the Power Cord through the center hole in the center of the BASE. Align the BASE front with the FAN front and insert the four posts on the FAN body into the four holes on the top of the BASE. Place the 4 SCREWS into the holes through the bottom of the base and tighten securely.

STEP 4: Route Power Cord

Run the power cord through the designated slot on the bottom of the BASE-back by tucking the cord under the tabs. Set the fan upright on the base; it is ready for use.

Control Panel and Remote

Control Panel Functions

• ON/OFF: Turns fan ON & OFF ▶️
• Speed Selection: Allows four different speed settings (ECO, Low, Medium, High) ?
• Timing Selection: Offers 15 settings in 1/2 hour increments, from 0.5 hours up to a maximum of 7.5 hours. LED indicators on the panel show 0.5h, 1h, 2h, 4h.
• Oscillating Selection: Starts and stops the oscillation of the fan.

Remote Control Usage

Point the top end of the remote directly at the front of the fan, aiming at the small window below the control panel. The remote operates on 2 AAA batteries.

Wind Modes

• Normal Wind: Uses the Low, Medium, and High fan speed settings.
• Sleeping Wind: Gradually lowers the fan speed to ECO over time. Options include:
  • (1) ECO Sleeping Wind: Airflow remains at ECO.
  • (2) Low Sleeping Wind: Starts at Low for 30 minutes, then drops to ECO.
  • (3) Medium Sleeping Wind: Starts at Medium for 30 minutes, then Low for 30 minutes, then ECO.
  • (4) High Sleeping Wind: Starts at High for 30 minutes, then Medium for 30 minutes, then Low for 30 minutes, then ECO.
• Natural Wind: Automatically selects wind speeds randomly, mimicking outdoor airflow patterns. Graphical representations are provided for:
  • (1) ECO Sleep Wind: 80-second cycle with ECO airflow.
  • (2) Low Natural Wind: 80-second cycle with Low speed most common.
  • (3) Medium Natural Wind: 80-second cycle with Medium speed most common.
  • (4) High Natural Wind: 80-second cycle with High speed most common.

Oscillating Angles

To change the oscillation angle, place hands on the fan body and turn it left or right. There are 5 positions. For full left-to-right oscillation, use the center or third position.

Storage & Cleaning Instructions

1. Turn off and unplug the fan before cleaning.
2. Wipe the housing with a soft cloth. Do not use water, gasoline, polish, or chemical solutions. Do not immerse the fan in water.
3. Use a vacuum cleaner with a brush attachment to clean intake and exhaust vents.
4. For a thorough cleaning, use compressed air to blow out dust from the vents.
5. Store the fan in a dry place away from excessive heat and direct sunlight.

Important Safety Instructions

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury.

1. Use this fan only as directed in this manual.
2. This fan is intended for personal use INDOORS only.
3. Do NOT place the fan near a window to avoid contact with outdoor elements or direct sunlight.
4. Operate the fan on a dry, level surface.
5. The fan has a polarized plug; ensure it fits correctly into the outlet.
6. Always turn the fan off and unplug it before transporting or cleaning.
7. When disconnecting, grip the plug firmly, not the cord.
8. Do NOT operate the fan if the cord or plug is damaged, or if the unit is malfunctioning.
9. Do NOT operate the fan in the presence of flammable or explosive fumes.
10. Keep the fan away from open flames and heat sources.
11. Do NOT operate the fan if the housing has been removed or damaged.
12. Avoid contact with the fan's moving parts.
13. Close supervision is necessary when the fan is operated near children.
14. Do NOT mount the fan on a wall or hang it from the ceiling.
15. Use of attachments is not recommended.
16. Do NOT use this fan with any solid-state speed control devices.
17. This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a person responsible for their safety.

Product Registration & Customer Service

To register your ULTRASlimline Tower Fan and receive information on new product offerings, visit: www.sevilleclassics.com/fan

For ULTRASlimline Tower Fan Parts & Accessories, visit: www.sevilleclassics.com

For questions, comments, or suggestions, contact Seville Classics Inc. at Tel: (800)-323-5565 or (310)-533-3800, or visit www.sevilleclassics.com.

PROOF OF PURCHASE: Please fill out the information below and forward this form and a copy of your original receipt with your defective appliance and/or parts to Seville Classics, Inc., 19401 South Harborgate Way, Torrance, CA 90501 – 1322, U.S.A.

Note on FCC Compliance

This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. The user is encouraged to try to correct the interference by reorienting or relocating the receiving antenna, increasing the separation between the equipment and the receiver, connecting the equipment into an outlet on a circuit different from that to which the receiver is connected, or consulting the dealer or an experienced radio/TV technician.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Batteries

The remote control operates on 2 AAA batteries. Do not mix old and new batteries, or mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. It is recommended that batteries be removed if the remote will not be used for an extended time. Install the two "AAA" batteries supplied as shown.