Autoslide AutoPlus Setup
This guide provides step-by-step instructions for setting up your Autoslide AutoPlus gateway.
Requirements
- Internet Service.
- Router with an available Ethernet port.
- Active Autoslide owner account for AutoSlide, MultiDrive, or AutoSwing.
Setup Instructions
Step 1: Connect the Antenna
Connect the antenna to the back of the AutoPlus and tighten by turning clockwise. Position the antenna to a straight up position.
[Diagram: The AutoPlus unit with an antenna being screwed into the back. The antenna is depicted in a straight-up position.]
Step 2: Connect the Ethernet Cable
Plug the Ethernet cord into your router and connect the other end to the back of the AutoPlus.
[Diagram: The AutoPlus unit with an Ethernet cable being plugged into the Ethernet port on the back.]
Step 3: Connect the Power Cable
Connect the power cable to the AutoPlus and plug the power adapter into a working outlet.
[Diagram: The AutoPlus unit with a power cable being plugged into the power port on the back, and the other end of the cable connected to a power adapter.]
Step 4: Check LED Indicators
Compare the lights on the AutoPlus to the LED Logo Indicator chart on page 2 to ensure they are functioning properly.
[Diagram: The AutoPlus unit with its LED logo illuminated, referencing a comparison to an indicator chart.]
Step 5: Complete App Setup
Complete your AutoPlus setup by following the “Pair a Device" instructions in the Autoslide app.
Before beginning the pairing process for AutoPlus, ensure the following:
- An AutoSlide, MultiDrive, or AutoSwing is installed and paired successfully to your phone as the owner.
- The latest version of the Autoslide app is downloaded and installed on your phone.
- AutoPlus is connected to the router and has a live internet connection.
[Diagram: A smartphone displaying the Autoslide app interface with various controls and a "Pair a Device" instruction.]
Step 6: Control Your Doors
After configuration, control your doors with the Autoslide app.
To test the Autoslide app, open the app, select your device, and press "Inside" to activate a door opening.
[Diagram: A hand holding a smartphone displaying the Autoslide app, with a finger about to tap an "Inside" button to activate a door opening.]
LED Indicator Chart
| Color | Meaning |
|---|---|
| White (solid) | Starting up |
| White (fade in and out) | Ready to pair |
| Blue | Normal operation |
| Amber (blinking) | Factory reset |
| Red | Not connected to internet |
| Magenta | Searching for Smart Lock |
| Amber (fade in, fade out) | Firmware download in progress |
| Amber (rapid blinking) | Updating firmware |
Reset the AutoPlus
Reset your AutoPlus Gateway by gently inserting a paperclip into the pinhole on the back of the unit. This will change the LED status to blue and then back to white.
The LED will briefly flash amber while the AutoPlus is resetting and rebooting.
[Diagram: The AutoPlus unit with a paperclip being inserted into a small pinhole on the back, near the power port, illustrating the reset procedure.]
Autoslide – Autoslide – Automatic Sliding Doors for homes
