Vollrath Cookware Grip Replacement Installation Instructions
Brand: Vollrath
Product Information
| Kit No. | Description | Includes |
|---|---|---|
| 7801 | Medium/Large Grips (fit 10", 12" and 14" pan handles) | 3 silicone grips (353780-1), 3 fasteners (353916-1) |
| 7811 | Small Grips (fits 8" pan handles) | 3 silicone grips (353781-1), 3 fasteners (353916-1) |
Replacing the Grip on Your Vollrath® Cookware
Remove Old Grip
- Face pan down and push the center button out with a pointed (not sharp) object.
[Illustration: Hand holding a tool pushing the center button on the underside of a pan handle. An arrow indicates the button being pushed inward. A small metal fastener is shown below.]
- Remove the fastener from the old silicone grip.
[Illustration: Hand using a screwdriver to remove a fastener from the base of an old silicone grip attached to a pan handle. An arrow indicates the fastener being removed.]
- Flip pan over and remove the old silicone grip from handle.
[Illustration: A pan handle viewed from the side, with the old silicone grip partially detached and being pulled away from the metal handle. An arrow shows the direction of removal.]
Install New Grip
- With pan facing up, slide new silicone grip onto the handle.
[Illustration: A hand sliding a new silicone grip onto the end of a metal pan handle. An arrow indicates the direction of sliding.]
- Place fastener (with the dot closest to pan) into the silicone grip-handle hole. Push the fastener down into place with a pointed (not sharp) object.
[Illustration: A hand inserting a metal fastener into the hole of the new silicone grip on the pan handle. The fastener has a small circular dot on one side. An arrow shows the fastener being pushed into place.]
- Flip the pan over and press around the flange center button to secure the fastener.
[Illustration: The underside of the pan handle showing the new silicone grip and the fastener being secured. A detailed inset diagram shows the fastener hole with numbered points (1, 2, 3, 4) around it, indicating areas to apply pressure. An arrow points from the handle to the inset diagram.]
