Lost Vape URSA EPOCH Pod Kit

Safety Warnings

• Warning for vulnerable consumer groups: This product is not recommended for minors, pregnant or breastfeeding women, or anyone at risk of heart disease, depression, and asthma.
• Battery Caution: Do not expose the device to extreme temperatures. Do not disassemble the device without Lost Vape's recommendation.
• Pod Cartridge Attention: Do not dry burn the tank or coil. It is essential to prime a new coil. Simply fill your tank with e-liquid and leave it to stand for at least 5 minutes before vaping. This allows the cotton inside your new coil to absorb plenty of e-liquid. All cartridges/coils are not covered under warranty once they are opened, used, or filled with liquids.
• Warranty: The device is covered by a 3-month warranty from the date of purchase.
• Contacts: For further questions or inquiries, please contact Lost Vape by email at support@lostvape.com or visit our website: www.lostvape.com.

Product Description

Components Overview

The URSA EPOCH Pod Kit includes the following components:

1. Pod
2. E-liquid Refilling Plug
3. 0.42-inch OLED Display
4. LED Indicator
5. Type-C Port
6. Lanyard Hole
7. Airflow Control Button
8. Air Inlet
9. Built-in 1000mAh Battery

Basic Parameters

• Dimension: 67.2*44.4*19.60mm
• Net Weight: 63g ± 3g
• Pod Capacity: 2.5ml / 2ml
• Battery Capacity: 1000mAh (built-in)
• Battery Voltage: 3.3V-4.2V
• Power Range: 17W-25W
• Charging Voltage: 5V/1A
• Type-C Cable: Supports 5V/2A Charger
• Body Material: Plastic + Silicone

Basic Operation

Fill with E-liquid

1. Take out the pod.
2. Open the e-liquid refilling plug.
3. Refill the pod from the filling slot.
4. Seal the plug after filling.
5. Put the pod back into the device.

Puff Time / Puff Count

• Puff Time will display after every vaping session.
• The peak display of puff count is 9999.
• To reset the puff count, plug in and out the pod 3 times within 3 seconds.

Display Information

The device display shows:

• Power Value
• Coil Resistance / Puff Time
• Battery Level
• Puff Count

Charging Indication

Vaping is allowed while charging at the power-on state. When charging, the screen displays the battery level:

• Below 3.7V: Indicated by a low battery icon.
• 3.7-3.79V: Indicated by one bar.
• 3.8-3.89V: Indicated by two bars.
• 3.9-3.99V: Indicated by three bars.
• 4.0-4.19V: Indicated by four bars.
• 4.2V: Fully charged, indicated by a full battery icon.

Warning Description

• Low Battery: When the battery voltage is lower than 3.3V before using, or lower than 2.85V while vaping, the LED indicator will flash red 3 times and output will automatically cut off.
• Open Circuit: When an open-circuit occurs or the resistance is greater than 2Ω, the LED indicator will flash purple 3 times, the resistance value displays "0.0", and there is no power output.
• Short Circuit: When a short-circuit occurs, the LED indicator will flash red 8 times, the resistance will display the actual value, and there is no power output.
• Over 10s: When you vape over 10 seconds continuously, the LED indicator will flash purple 8 times and the output will be automatically cut off.