Lost Vape Centaurus E40 Max Pod Kit User Manual

Safety Warnings

• Vulnerable Consumer Groups: Not recommended for minors, pregnant or breastfeeding women, or individuals at risk of heart disease, depression, and asthma.
• Battery Caution: Do not expose the device to extreme temperatures. Do not disassemble the device without Lost Vape's recommendation.
• Cartridge Attention: Do not dry burn the cartridge or coil. Prime new coils by filling the tank with e-liquid and letting it stand for at least 5 minutes before vaping. Cartridges/coils are not covered under warranty once opened, used, or filled with liquids.
• Warranty: The device is covered by a 3-month warranty from the date of purchase.
• Contacts: For questions, contact Lost Vape via email at support@lostvape.com or visit www.lostvape.com.

Components Overview

• ① Mouthpiece
• ② Cartridge
• ③ E-liquid Refilling Plug
• ④ Lanyard Hole
• ⑤ Fire Button
• ⑥ Airflow Control Button
• ⑦ Single Panel Indicator
• ⑧ 0.42” OLED Screen
• ⑨ Right / “+” Button
• ⑩ Left / “-” Button
• ⑪ Type-C Port

Basic Operation

Fill with E-liquid

1. Take out the pod.
2. Open the e-liquid refilling plug.
3. Refill the pod from the filling slot.
4. Seal the plug after filling.
5. Put the pod back into the device.
6. Leave it to stand for at least 5 minutes before vaping.

Turn On / Off

Press the Fire button 5 times consistently within 2 seconds to turn the device ON/OFF.

Adjustment Lock/Unlock

Press the Fire button and the “+” Button simultaneously to Lock/Unlock the buttons. The Auto Draw feature remains operational in this mode.

How to Adjust Wattage

Short press the Right (+) & Left (-) Buttons to increment/decrease power by 0.5W steps; long press for rapid adjustment. Different coil resistances have different max./min. power limits. The device will prompt "Max Power" when the maximum limit is reached. Short press again to return to the minimum power value.

Puff Time Display & Puff Count Reset

• Puff time starts counting when it reaches 0.5s. The maximum puff count display is 9999.
• Press the Fire button and the Left (-) button simultaneously within 3 seconds to reset the puff count.

Charging Mode

When the battery is charging, the screen will display the charging status.

Device Status Indicators

• Low Battery: LED panel indicator flashes red 10 times. Output cuts off when battery voltage is below 3.3V before use or lower than 2.85V during use.
• Check Atomizer: LED panel indicator flashes purple 3 times when no atomizer is detected.
• Short Circuit: LED panel indicator flashes red 3 times with no output when the atomizer is short-circuited.
• Too Hot: LED panel indicator flashes red 10 times, and the device shuts down when the internal board temperature is too high. Use again when the temperature returns to 60°C.
• Over 10s: Output cuts off automatically, and the LED panel indicator flashes purple 3 times when vaping continuously for over 10 seconds.

Basic Parameters