BISSELL CleanView Rewind Upright Vacuum

Assembly

For assembly videos, visit support.BISSELL.com.

1. Attach wand to vacuum base.
2. Attach stretch hose to wand and twist clockwise to lock into place.
3. Attach stretch hose to the back of the vacuum and twist clockwise to lock into place.
4. Attach hose clip to the body of the vacuum by sliding up until it clicks into place. Remove the hose clip for extended cleaning reach when in use.
5. Ensure the hose sits on the vacuum without any twists.
6. Attach tools to tool holders.

Using the Vacuum

For additional support videos and information, visit support.BISSELL.com.

1. Gently pull the cord out, stopping at the yellow mark. Do not pull past the red mark.
2. Press the red power button [power-symbol] with your foot to turn the vacuum ON and OFF [power-symbol].
3. Press the recline pedal and pull the handle back towards you.
4. Turn dial on foot to desired height setting. If the dial is difficult to turn, tilt the vacuum back slightly to take the weight off the foot while turning. For best performance, adjust to the lowest practical setting. If your vacuum is difficult to push, adjust to the next higher setting.
5. Hold onto the plug and press the automatic cord rewind button [rewind-symbol] until fully retracted. If the cord doesn't fully retract on the first try, pull a little bit of cord out and press the rewind button again.

Note: The rotating floor brush continues to rotate while tools are in use. Never place fingers under the vacuum when it is running. Never place the powerfoot on furniture or uneven surfaces.

Certain carpets and low humidity conditions may generate small static discharges. These are harmless and not associated with the main power supply.

Above Floor Cleaning

Clean hard-to-reach spaces with the Quick Release Extension Wand.

1. Push the release button [release-button-symbol] to remove the extension wand and attach the desired tool.
2. Attach the desired tool.
3. Note: For optimal performance, attach the Pet TurboBrush® Tool directly to the hose instead of the wand.
4. Twist the hose counter-clockwise to remove it from the handle, if desired. To do so, twist the circular hose cuff counter-clockwise and remove it from the handle.

WARNING: To reduce the risk of injury from moving parts while the vacuum is turned ON, always move the vacuum via the rolling wheels by using the upper handle at the back of the vacuum. Do not carry the vacuum while it is running. Always place the vacuum on the floor with the handle in an upright position when using tools.

Maintaining Your Vacuum

For more helpful maintenance tips, check out support.BISSELL.com.

Maintaining the TurboBrush® Tool

1. Twist the gray collar counterclockwise until a slot appears; separate the faceplate and remove the brush. Replace the belt and brush if needed.
2. If the paddle wheel is dislodged, align the two clips on each side and click into place.
3. The faceplate will not close if all parts are not aligned correctly.

Replacing the Brush and Belt

1. Unplug the vacuum, turn it over, and unscrew the six Phillips-head screws to remove the bottom cover.
2. Lift the brush roll straight out. Inspect the belt and replace it if it appears damaged.
3. If the belt is not broken, inspect the brush roll by placing it on its end and spinning it. The brush roll should spin freely, multiple times with one flick. Replace the brush roll if it doesn't spin freely.
4. Replace the brush roll and belt by looping the belt over the motor shaft and brush roll. Line up the end caps and pull the brush forward into place. The belt will stretch.
5. Once the brush roll is installed, place the bottom cover back on and replace the screws.

Clearing a Clog

1. Remove the hose from the back of the vacuum by twisting left. Remove any debris.
2. Check the foot hose on the back of the vacuum, towards the bottom. If necessary, remove the screw from the foot hose and check for clogs.
3. Check the air passageway on the bottom of the vacuum. Remove the bottom cover and brush. Remove any debris.

Emptying the Dirt Tank

We have additional tips for maintaining your machine at support.BISSELL.com.

1. Press the tank release button [release-button-symbol] and pull out to remove the dirt tank.
2. Hold the dirt tank over a trash bin. Press the bottom release button to empty.
3. Twist the cyclone counter-clockwise and pull down to remove it from the tank.
4. Clean the cyclone with warm water and mild detergent. Let it dry for 24 hours before reinstalling.
5. Twist the cyclone clockwise to reinstall.
6. Place the tank back on the vacuum and press firmly until it clicks into place.

Cleaning the Pre-Motor Filter

Find replacement filters at BISSELL.com.

1. Press the tank release button [release-button-symbol] and pull out to remove the dirt tank.
2. Lift the release latch to access the filter. Remove the foam filter from the lid.
3. Hand wash in warm water and rinse well; mild detergent may be used if desired. Let it dry for 24 hours before reinstalling.
4. Reinstall the foam filter and close the lid.
5. Place the tank back on the vacuum and press firmly until it clicks into place.

WARNING: To reduce the risk of electric shock, turn power OFF and disconnect the plug from the electrical outlet before performing maintenance or troubleshooting checks. Do not operate the vacuum with damp or wet filters or without all filters in place.

Troubleshooting

For a comprehensive walkthrough of your product and support tips, visit support.BISSELL.com.

WARNING: To reduce the risk of electric shock, turn power OFF and disconnect the plug from the electrical outlet before performing maintenance or troubleshooting checks.

Product Overview

1. Handle

2. Stretch Hose

3. Wand Release Button

4. Tank Release Button

5. Carry Handle

6. Dirt Tank

7. Cord Rewind Button

8. Power Pedal

9. Recline Pedal

10. Height Adjustment

Important Safety Instructions

READ ALL INSTRUCTIONS BEFORE USING YOUR APPLIANCE.

When using an electrical appliance, basic precautions should be observed, including the following:

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:

• Do not leave vacuum cleaner when it is plugged in. Unplug from outlet when not in use and before servicing.
• Do not use outdoors or on wet surfaces.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children.
• Do not use for any purpose other than described in this user guide.
• Use only manufacturer's recommended attachments.
• Do not use with a damaged cord or plug. If the appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or vacuum cleaner with wet hands.
• Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
• Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
• Turn OFF all controls before plugging or unplugging vacuum cleaner.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.
• Do not use vacuum cleaner in an enclosed space filled with vapors given off by oil-based paint, paint thinner, some moth-proofing substances, flammable dust, or other explosive or toxic vapors.
• Do not use to pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
• Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.
• Do not use without filters in place.
• Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
• Use only on dry, indoor surfaces.
• Keep appliance on a level surface.
• Do not carry the vacuum cleaner while it is running.
• Unplug before connecting or disconnecting the Pet TurboBrush® Tool.
• Before using your vacuum, make sure the dirt tank is in the locked position and that all filters, both pre- and post-filters, are in place. DO NOT operate your vacuum without these filters.
• Plastic film can be dangerous. To avoid danger of suffocation, keep away from children.
• Do not plug in your vacuum UNTIL you are familiar with all instructions and operating procedures.
• Hold plug when rewinding into cord reel. Do not allow plug to whip when rewinding.

COMMERCIAL USE OF THIS MACHINE VOIDS THE MANUFACTURER'S WARRANTY.

THIS APPLIANCE HAS A POLARIZED PLUG

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.

SAVE THESE INSTRUCTIONS

THIS MODEL IS FOR HOUSEHOLD USE ONLY.

Warranty

Limited 2-year warranty, may vary by state. Visit support.BISSELL.com or call 1-800-237-7691 for complete warranty information.

What's in the Box?

Standard accessories may vary by model. To identify what should be included with your purchase, please refer to the "Carton Contents" list located on the carton top flap.

Base

Wand

Hose

Crevice Tool

Dusting Brush

Pet TurboBrush® Tool

Every Purchase Saves Pets™

BISSELL proudly supports BISSELL Pet Foundation® and its mission to help save homeless pets. When you buy a BISSELL® product, you help save pets, too. BISSELL is proud to design products that help make pet messes, odors and pet homelessness disappear. Visit BISSELLsavespets.com to learn more.

Meet your new BISSELL product!

Go to support.BISSELL.com for a comprehensive walkthrough of your new purchase, including videos, tips, support, and more. Want to get started right away? This guide has all the information you need to set up your new product. Let's take a look...