ITEM NO. : B3333BU ASSEMBLY INSTRUCTIONS

Assembly Steps

1. Attach the lampshade (A) to the canopy (B) with the screws (C) and then secure the screws with the nuts (D).
2. Install the mounting plate (E) on the outlet box with the screws (F).
3. Loosen the hex nuts around the bolts (G) and screw in or unscrew the bolts from the junction box to get the right length for installation.
4. Connect the fixture wire to the circuit wire with the wire nuts (H): black wire with live wire, white wire with neutral wire, ground wire with ground wire. Turn the wire nuts to twist the wires together. Wrap the wire nuts with insulated rubber tape.
5. Fix the lamp body (B) to the mounting plate (E) with ball nuts (J).
6. Screw the bulb (K) into the lamp holder.

Wiring Diagram Description

The diagram illustrates the electrical connections required for installation. It shows an outlet box mounted on a wall, with wires labeled "Ground Wire", "Live Wire" (typically black), and "Neutral Wire" (typically white) emerging from it.

The fixture includes corresponding wires: "Black Wire", "White Wire", and a ground wire. These are connected to the respective household wires using wire nuts (H). The diagram shows a mounting plate (E) secured to the outlet box with screws (F). Bolts (G) are used to adjust the plate's position. The main body of the fixture, referred to as canopy (B), attaches to the mounting plate (E) using ball nuts (J). The lampshade (A) is attached to the canopy (B) using screws (C) and secured with nuts (D). Finally, a bulb (K) is screwed into the lamp holder.

Key components labeled: A (Lampshade), B (Canopy/Lamp Body), C (Screws), D (Fasteners), E (Mounting Plate), F (Screws), G (Bolts), H (Wire Nuts), J (Ball Nuts), K (Bulb).

Recommended Bulb Shapes

Light Distribution

A stylized diagram shows the light distribution pattern of the fixture, indicating how light is cast.