INSTALLATION MANUAL
CHANDELIER
Model No.: HLP12505BQG
HARMONIZE AND INSTALL BULBS
1. Adjust the Balance
Adjust the length of the wire by pressing the wire lockers as shown in the diagram.
Diagram shows a chandelier fixture with wires and wire lockers. An arrow indicates pressing the wire lockers to adjust wire length.
2. Install the Bulbs
Use E12 bulbs, maximum 40W each. LED bulbs are recommended (not included).
Note: To achieve dimming functionality, use dimmable bulbs and a dimmer switch.
Diagram illustrates the chandelier fixture with 10 sockets, indicating where to install the E12 bulbs.
INSTALL THE CRYSTALS
Multi-step diagram showing the process of attaching crystals. Step 1: Insert the connector between FF/GG into the slot opening of B. Step 2: Secure FF/GG downward. Step 3: Arrange the crystals in the sequence "FF/GG/FF/GG" and repeat this group order.
TOOLS REQUIRED
- Ladder
- Pliers
- Wire Strippers
- Screwdrivers
PACKING LIST
INSTALLATION KIT
| Part Label | Description | Quantity |
|---|---|---|
| A | Canopy | 1x |
| B | Lamp Body | 1x |
| AA | Mounting Bracket | 1x |
| BB | Mounting Screw | 2x |
| CC | Ground Screw | 1x |
| DD | Wire Nut | 3x |
| EE | Knueled Nut | 2x |
| FF | Crystal A | 35x (1 spare) |
| GG | Crystal B | 35x (1 spare) |
| HH | Gloves | 1x |
Note: 1. CC is pre-installed on AA, AA/EE is pre-installed on A. 2. FF/GG has one spare part for backup.
MOUNTING AND WIRE
1. Install the Mounting Bracket
Step 1: Loosen the knueled nut (EE) from canopy (A), take out the mounting bracket (AA).
Step 2: Take off the screws from the outlet box, secure the mounting bracket (AA) onto the box with the screws taken off or screws provided (BB).
Diagram shows the mounting bracket (AA) being attached to the ceiling electrical box using screws (BB). It also shows loosening a knueled nut (EE) from the canopy (A).
2. Connect the Wires
Step 1: Connect the wires from the fixture to the house supply wires with wire nuts (DD). Connect the ground wire (green, green/yellow, or bare) to the ground wire, the neutral wire (white) to the neutral wire, and the hot wire (black) to the hot wire. Wrap the connection with electrical tape.
Step 2: Spread apart the wires so that the hot wires are on one side of the outlet box and the neutral wires are on the other side.
Diagram illustrates electrical wire connections: fixture wires (Neutral wire (N), Hot wire (L), Ground wire) to house supply wires using wire nuts (DD).
3. Fix the Canopy
Fix the canopy (A) onto the mounting bracket (AA) with the knueled nuts (EE) taken off.
Diagram shows the canopy (A) being secured onto the mounting bracket (AA) using knueled nuts (EE).
