Wolf New Pro Induction Range Design Guide

Planning Information

Follow all minimum clearances to combustible surfaces as shown in the illustrations. For 48-inch models, two separate electrical supplies are required. Position receptacles with grounds facing each other to prevent cord interference.

Diagram 8: Illustration of two electrical outlets with grounding connections, demonstrating the requirement for separate electrical supplies for 48-inch models.

Electrical Requirements

Installation must comply with all applicable electrical codes. Locate the electrical supply flush with the wall or floor. A separate circuit servicing only this appliance is required. If a power supply cord is used, it must be rated for 240 V, 50 amps, and include 3 or 4 conductors. A 4-conductor cord is required for installations where grounding through the neutral is prohibited. Performance may be compromised if the electrical supply is less than 240 volts. IMPORTANT NOTE: Two separate electrical services are required for 48-inch models.

Electrical Requirements:

*Note: Two services are required for 48-inch models.

Diagram 9: Representation of a typical rating plate found on the appliance.

Wolf Appliance Residential Warranty

FOR RESIDENTIAL USE

FULL TWO YEAR WARRANTY*

For two years from the date of original installation, this Wolf Appliance product warranty covers all parts and labor to repair or replace, under normal residential use, any part of the product that proves to be defective in materials or workmanship. All service provided by Wolf Appliance under this warranty must be performed by Wolf Factory Certified Service, unless otherwise specified by Wolf Appliance, Inc. Service will be provided during normal business hours.

LIMITED FIVE YEAR WARRANTY

For five years from the date of original installation, Wolf Appliance will repair or replace the following parts that prove to be defective in materials or workmanship: gas burners (excludes appearance), electric heating elements, blower motors (ventilation hoods), electronic control boards, magnetron tubes, and induction generators. If the owner uses Wolf Factory Certified Service, the service provider will repair or replace these parts, with the owner paying for all other costs, including labor. If the owner uses non-certified service, the owner must contact Wolf Appliance, Inc. to receive repaired or replacement parts. Wolf Appliance will not reimburse the owner for parts purchased from non-certified service or other sources.

TERMS APPLICABLE TO EACH WARRANTY

The warranty applies only to products installed for normal residential use in the United States (including the District of Columbia) or Canada. This warranty does not cover any parts or labor to correct any defect caused by negligence, accident, improper use, maintenance, installation, service, or repair.

The remedies described above are the only ones Wolf Appliance, Inc. will provide. Wolf Appliance, Inc. will not be responsible for any consequential or incidental damages arising from the breach of this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights that vary from state to state.

To receive parts and/or service and the name of Wolf Factory Certified Service nearest you, contact Wolf Appliance, Inc., P.O. Box 44848, Madison, WI 53744; check the Product Support section of their website, wolfappliance.com; email customerservice@subzero.com; or call 800-222-7820.

*Stainless steel (doors, panels, handles, product frames and interior surfaces) are covered by a limited 60-day parts and labor warranty for cosmetic defects. *Replacement filters for ventilation hood recirculating kits are not covered by the product warranty.