Hilti MT-CTR GL OC Installation Guide
Product Overview
This document provides instructions for the installation of the Hilti MT-CTR GL OC system. It includes details on the components, assembly steps, and required tools and torque specifications.
Components
Set Components:
- 2x MT-CTR GL OC Set
- 2x Hexagonal nuts
- 2x Washers
Extra Components:
- 1x Rod
- 4x MT-TFB (Threaded Fastener Bolt)
- 1x Channel (MT-80 / MT-90 / MT-90H / MT-100)
- 1x Channel (MT-80 / MT-90 / MT-90H / MT-100)
Installation Steps
-
Step 1: Positioning
Ensure the distance between the support points is greater than 15mm. The vertical distance from the support to the channel should be 0 mm.
-
Step 2: Attaching the Bracket
Attach the MT-CTR GL OC bracket to the support structure using the provided fasteners.
-
Step 3: Securing the Channel
Position the channel and ensure the distance from the support is greater than 0 mm. Secure the channel using the MT-TFB fasteners.
-
Step 4: Finalizing the Connection
Ensure the distance from the support is greater than 0 mm. Tighten the fasteners securely.
-
Step 5: Torque Specifications
Refer to the table below for the correct torque values for different bolt sizes.
Bolt Size Torque M12 30 Nm M16 70 Nm 1/2" 30 Nm 5/8" 70 Nm -
Step 6: Final Check
Ensure all components are securely fastened and the installation meets the specified requirements. The MT-TFB is used for securing the channel.
