Hilti MT-CTR GS OC System
Document Number: 2334574-07.2021
Product Overview
This document provides instructions for the Hilti MT-CTR GS OC system, a versatile mounting solution for construction applications. It details the components, assembly steps, and necessary specifications for proper installation.
Components
Set Components
- 2x MT-CTR GS OC Set (U-shaped bracket)
- 2x Nut with plate
- 2x Nut
- 2x Washer
Extra Components
- 4x MT-TFB (Bolt)
- 2x Rod (M12 / M16 / 1/2" / 5/8")
- 1x Channel (MT-70 / MT-80)
Installation Steps
Step 1: Initial Rod Placement
Diagram illustrating the initial placement of a threaded rod relative to a nut. An attention icon ⚠️ and '0mm' indicate precise alignment is required.
Step 2: Bracket and Fastener Assembly
Illustration of the components for assembly: a U-shaped bracket, a bolt, and a washer.
Step 3: Attaching Bracket to Rod
Shows a threaded rod being inserted into a bracket. Red arrows indicate vertical adjustment. A magnified view shows a bolt being tightened, with an attention icon ⚠️ and '> 0mm' indicating clearance is required between the bracket and the channel.
Step 4: Securing Bracket to Channel
Illustrates attaching the bracket assembly to the perforated channel rail. Red arrows show adjustment. A magnified view shows a bolt being tightened, with an attention icon ⚠️ and '> 0mm' indicating clearance is required.
Step 5: Torque Specification
Depicts the use of a torque wrench to tighten fasteners, indicated by the '[Tinst]' symbol. The following table provides torque specifications for various bolt sizes:
| Bolt Size | Torque |
|---|---|
| M12 | 30 Nm |
| M16 | 70 Nm |
| 1/2" | 30 Nm |
| 5/8" | 70 Nm |
Step 6: Final Assembly with MT-TFB
Shows the final attachment of the MT-TFB component to the channel rail using a torque wrench, indicated by the '[Tinst]' symbol. The required tools, a wrench and a TX50 bit, are illustrated, along with the part number SI-AT-A22.
