Electric Strike Model ES-201 Installation
(Other brand of electric strike will not work for this swing door opener)
Wiring
Connect the 2 wires to the electric strike terminals.
[Diagram Description: An illustration shows an electric strike being installed on a door frame. Two wires are shown extending from a door opener mechanism towards the electric strike terminals. A magnified inset details the connection points on the electric strike, showing two wires being attached to screw terminals.]
The other end of the wire should be plugged into the door opener, the most up left jumpers, as shown.
Jumper Connection
Connect J1 to enable electric strike.
[Diagram Description: An illustration shows the main body of the electric strike unit. A magnified inset focuses on the internal circuit board, highlighting jumper pins. An arrow points to a specific jumper position labeled J1.]
Connect this jumper J1.
Ensures these 2 jumpers are connected.
