Satechi USB4 Slim NVMe Enclosure
SKU: ST-EU4SNSS
Installation Guide
-
Step 1
To install the NVMe SSD, rotate the enclosure's bottom cover clockwise to unlock it and lift the cover. The SSD accessories and connection cable are included. The cable can be stored inside.
Diagram Description: Shows the bottom cover of the enclosure being rotated counter-clockwise to unlock, with arrows indicating the direction of rotation. The enclosure is depicted from a top-down view.
-
Step 2
Before installing the SSD, be sure to apply the included thermal tape. Remove the clear film and attach that side to the enclosure. Once attached, remove the blue film from the side that will contact the SSD.
Diagram Description: Illustrates applying a thermal tape to the inside of the enclosure lid. One side of the tape is shown attached to the enclosure, with an arrow pointing to the removal of a blue protective film from the other side of the tape.
-
Step 3
Insert the SSD (not included) at a slight angle and fully seat it in the PCIe slot. The enclosure is not compatible with some double-sided SSDs or SSDs with pre-installed heatsinks.
Diagram Description: Shows an NVMe SSD being inserted into the enclosure's PCIe slot at a slight angle. Arrows indicate the direction of insertion and the SSD seating into the slot.
-
Step 4
Secure the SSD using the included screw and screwdriver. Tip: To prevent stripping the screw, do not over-tighten.
Diagram Description: Depicts a small screw being used to secure the NVMe SSD in place within the enclosure, with a screwdriver shown. An inset highlights the screw insertion point.
-
Step 5
Remove the USB-C cable from the device.
Diagram Description: Shows a USB-C cable being disconnected from a device.
-
Step 6
Reattach the cover by turning it counterclockwise until the arrow aligns with the notch and it clicks into place.
Diagram Description: Illustrates the enclosure's bottom cover being placed back on and rotated clockwise to lock, with arrows showing the alignment of the cover's arrow with the enclosure's notch.
-
Step 7
Flip the enclosure back over.
Diagram Description: Shows the enclosure being flipped from its side to its upright position.
-
Step 8
Connect the USB-C cable to the enclosure and then to your computer's USB-C port. Up to 40Gbps theoretical transfer speeds with compatible NVMe M.2 drives and host devices.
Diagram Description: Shows the USB-C cable connecting the Satechi enclosure to a computer's USB-C port. The computer is depicted with various ports, including HDMI and USB-C.
If using a new NVMe drive, please ensure it is properly formatted to support your desired host device(s).
